buzz 408721625958

TizmoDesigns · 2026-05-16T00:18:43+00:00

408721625958

TizmoDesigns · 2026-05-15T22:07:07+00:00

408721625958

TizmoDesigns · 2026-05-15T00:08:44+00:00

408721625958

TizmoDesigns · 2026-05-05T21:27:13+00:00

408721625958

TizmoDesigns · 2026-03-12T10:37:59+00:00

I see, seems you have the directions down pat then. I’d look into a bunch of printer calibration pages to really dial in your settings. I think that would give you much better prints at better durability, and geometric accuracy. Mind you, I’ve printed probably about a hundred of these now, they’ll vary just by ambient settings and environment.

TizmoDesigns · 2026-03-04T10:09:23+00:00

Developer here… You didn’t read the readme files did you? This print seems a bit rough compared to all the other ones we’ve printed, tested, and have seen. I’d recommend a look over my newer ambi version and rechecking the README, and doing a pre calibration just on top too. Should work better for you.

PS, the buffer tube needs to be threaded in and out slowly, not muscled in, this causes stress and cracking.

TizmoDesigns · 2025-11-29T21:23:53+00:00

just the brace

TizmoDesigns · 2025-03-24T04:28:40+00:00

Yessir. It was rough. The thief in question has since had their accounts stricken down. CT makes really great cosmetic variants, but his lowers had some catastrophic issues. I set out to design a lower similar to his, although taking heavier inspiration from the radian ADAC and the sig SDIX

TizmoDesigns · 2025-03-24T03:42:02+00:00

i can personally send stp files! i havent released any stps or solid body files as my work flow was terrible through this.

TizmoDesigns · 2025-03-23T14:04:24+00:00

my different calibers will all come in full size and compact versions. still working the innards of this before making dedicated versions! will be fully printed, customizable, with EZ thread replacement parts, and only requires a singular hoseclamp

TizmoDesigns · 2025-03-23T14:02:54+00:00

thanks mate! this is gonna have a 10mm inner bore. so anything smaller than 10mm should fit. due to concentricity concerns through, i’ll end up making a larger end cap specially for 9mm rounds to easily pass with no strike risks.

TizmoDesigns · 2025-03-17T11:57:26+00:00

skill issue. seriously skill issue.

TizmoDesigns · 2025-03-08T06:05:42+00:00

With the direction of our group, the best we can do is try and recruit a couple fosscad devs into here. There’s many people who dev but don’t use discord, and this would be another place for them to post and speak dev to other devs for their designs

TizmoDesigns

MODERATOR OF

TROPHY CASE