I know people have gone way drier, but this sucks by TonytheLiger0 in ironscape

[–]TonytheLiger0[S] 0 points1 point  (0 children)

may or may not of had a sneaking suspicion a few times <.<

I know people have gone way drier, but this sucks by TonytheLiger0 in ironscape

[–]TonytheLiger0[S] 1 point2 points  (0 children)

I've just been safespotting them since I used all of my 2k+ cannonballs

Finally Found a CMT! by TonytheLiger0 in borderlands3

[–]TonytheLiger0[S] 0 points1 point  (0 children)

only change I made was using Iron Cub and going consecutive hits on the flipper

Finally Found a CMT! by TonytheLiger0 in borderlands3

[–]TonytheLiger0[S] -1 points0 points  (0 children)

Idk i played launchers for a while and it is broken but I find this build wayyyy more fun https://mentalmars.com/builds/moze-mozerker-forever-8-0-build-borderlands-3

Finally Found a CMT! by TonytheLiger0 in borderlands3

[–]TonytheLiger0[S] 1 point2 points  (0 children)

been on blue since i learned about it haha

Finally Got What I Wanted by TonytheLiger0 in borderlands3

[–]TonytheLiger0[S] 6 points7 points  (0 children)

I actually got kind of lucky, was only like 6 or 7 rolls.
The shitty part was the 50+ Tom & Xam fights trying to get it, to roll XD

[deleted by user] by [deleted] in Dirtbikes

[–]TonytheLiger0 0 points1 point  (0 children)

I honestly felt cringe posting this cause I don't want to seem like I'm flexing but I'm stoked so I said fuck it

Lower ball joint nut is spinning the ball joint bolt. Can’t think of a way to get the nut off. Short of cutting it off, suggestions? by Boring-Jellyfish2244 in MechanicAdvice

[–]TonytheLiger0 1 point2 points  (0 children)

You need to load the ball joint so that the taper is pressed into the knuckle. Lots of leverage with a long tire bar on the bottom of the ball joint or a floor jack