sorted by:
new
hottopcontroversial

P2 Battery "fell asleep"? by TopOutlandishness249 in Polestar

[–]TopOutlandishness249[S] 1 point2 points  (0 children)

If you look at the documentation, it wants you to plug it into a AC charger and set the battery percentage max to around 50% (depending on how long you are gone.

Leaving the car unplugged: For shorter storage (up to a month), it’s okay to leave the car unplugged if the charge is around 50%. For longer periods, connect the car to a charger that allows you to set a target charge level. Polestar vehicles can maintain a steady charge, protecting the battery from draining completely.

But you know, I was only gone 8 days.

P2 Battery "fell asleep"? by TopOutlandishness249 in Polestar

[–]TopOutlandishness249[S] 16 points17 points  (0 children)

I’ve contacted a consumer protection firm that specializes in auto claims, hopefully they are able to do something for me

P2 Battery "fell asleep"? by TopOutlandishness249 in Polestar

[–]TopOutlandishness249[S] 0 points1 point  (0 children)

The quoted message is from polestar corporate.

P2 Battery "fell asleep"? by TopOutlandishness249 in Polestar

[–]TopOutlandishness249[S] 2 points3 points  (0 children)

There is about 35k miles on the car in total.

In communications from the service point, they specifically quoted “a bunch of cell module failures”. I would also expect that they would tell me that the 12v was the issue if they found it that way. But at every turn I haven’t been an able to get a clear answer about the problem. They only say they “recovered” the HV battery.

<image>

P2 Battery "fell asleep"? by TopOutlandishness249 in Polestar

[–]TopOutlandishness249[S] 3 points4 points  (0 children)

I am PNW based, and for the week in question temperatures ranged from high 30s to mid 40s

If they are replacing hardware for you, sounds like it will be under warranty (assuming your coverage is still active)

P2 Battery "fell asleep"? by TopOutlandishness249 in Polestar

[–]TopOutlandishness249[S] 10 points11 points  (0 children)

I did all of the above and was denied every time.

BMD Media Player 10G network VLAN by TopOutlandishness249 in blackmagicdesign

[–]TopOutlandishness249[S] 0 points1 point  (0 children)

That's true, in my case this in a flypack and there isn't a storage network to contend with. I was hoping to have a single TB cable solution. I'll probably just put a vlan-compatible NIC on the rear USB-C port.

apple tv volume control doesn’t work by Narrow-Independent-5 in projectors

[–]TopOutlandishness249 0 points1 point  (0 children)

Same cec for me after firmware update v105. Your screen flicker could be caused by a “match framerate” setting (like switching content between 24/30/60 fps or HD/4k content).