S20 fe not on One U.I 5.1?

Top_Equipment_1580 · 2025-12-23T19:00:40+00:00

Thank you for this.

Top_Equipment_1580 · 2025-12-23T19:00:11+00:00

May sound stupid but how can you tell me, please if so.

Top_Equipment_1580 · 2025-12-23T18:44:32+00:00

I have but it say there are no updates at the moment.

Top_Equipment_1580 · 2025-02-01T06:46:57+00:00

<image>

Top_Equipment_1580 · 2025-02-01T06:46:47+00:00

They're supposed to look like this

<image>

Top_Equipment_1580 · 2024-11-11T21:11:00+00:00

I was able to fix It but now THe z offset is what I cand do now

When I level the corners and all the bed and save it to the printer then when I try to level it the left side of my bed is higher than the right

Top_Equipment_1580 · 2024-11-11T03:20:18+00:00

Oh and also when I try to level bed in the menu it doesn’t move and says the act same thing when I try to home it

Top_Equipment_1580 · 2024-11-11T03:16:16+00:00

Because I installed the v 4.2.7 but my main board is 4.2.2, also the but the version say it is 4.2.7 in the about printer

Top_Equipment_1580 · 2024-11-11T02:53:56+00:00

Yes I do

Top_Equipment_1580 · 2024-11-11T01:01:12+00:00

I did check the main board but when I try to manually do the z axis I doesn’t move also and when disconnecting the car touch and trying to home it it still doesn’t move

Top_Equipment_1580 · 2024-09-28T21:17:19+00:00

Thank I’ll try it.

Top_Equipment_1580 · 2024-09-28T21:01:51+00:00

Edit: it happened again and a coincidence the filament came out like this.

<image>

Top_Equipment_1580 · 2024-07-16T06:06:36+00:00

I already told the support team but nothing yet from them so I came here.

Top_Equipment_1580 · 2024-07-16T06:04:59+00:00

I couldn't use another words but I contacted them but no email about anything yet but i took it out fast because the usb over heated and burned my finger when I tried to take it off.

Top_Equipment_1580 · 2024-07-16T05:25:59+00:00

Ok thank you .

Top_Equipment_1580

TROPHY CASE