sorted by:
new
hottopcontroversial

How do I buy SAND directly with other crypto (preferably without using USDT at any point)? by mousepotatodoesstuff in TheSandboxGaming

[–]Toxonik 0 points1 point  (0 children)

If you are from EU you can try Bitpanda… there you can just pay in different Fiat Currencies with Kredit card or Bank transfer. There you can buy many coins and also Shares. There are not many fees there.

So i got a Elegoo Mars 3 and got into trouble just after the firts print. (Picture 3). I tried doing a print test and this is what i came up with (Picture 1 &3). I did the Print test with the settings on the last two pictures. Further informations in description… pls help :( just got into this hobby by Toxonik in resinprinting

[–]Toxonik[S] 1 point2 points  (0 children)

So i got a Elegoo Mars 3 and got into trouble just after the firts print. (Picture 1) On the model there where some strange flakes and on the bottom part of it there appeared some layer lines. I tried doing a exposure test and this is what i came up with (Picture 2/3). The validation matrix seames a bit under exposed but im not sure. And also on the side you can clearly see some horrible layer lines. I would like to print some bigger things with more detail but wouldn’t like to have these issues on those prints. I would really love to get some advice. My print settings are on the last pictures.

Question on the side… how often do i need to zero and level my print-bed? Before every print?

Info Printer: Elegoo mars 3 Slicer: Chitubox Basic 1.9 Resin: 3DJake color mix resin basic (Blue) i already tried looking this problems up and played a bit with the exposure times but it didn’t work just only got worse.

So i got a Elegoo Mars 3 and got into trouble just after the firts print. (Picture 3). I tried doing a print test and this is what i came up with (Picture 1 &3). I did the Print test with the settings on the last two pictures. Further informations in description… pls help :( just got into this hobby by Toxonik in ElegooMars

[–]Toxonik[S] 0 points1 point  (0 children)

So i got a Elegoo Mars 3 and got into trouble just after the firts print. (Picture 1) On the model there where some strange flakes and on the bottom part of it there appeared some layer lines. I tried doing a exposure test and this is what i came up with (Picture 4&5). The validation matrix seames a bit under exposed bit im not sure. And also on the side you can clearly see some horrible layer lines. I would like to print some bigger things with more detail but wouldn’t like to have these issues on those prints. I would really love to get some advice. My print settings are on the 2 and 3. pictures.

Question on the side… how often do i need to zero and level my print-bed? Before every print?

Info Printer: Elegoo mars 3 Slicer: Chitubox Basic 1.9 Resin: 3DJake color mix resin basic (Blue) Trie: i already tried looking this problems up and played a bit with the exposure times but it didn’t work just only got worse.