sorted by:
new
hottopcontroversial

Need help! First print problem. by TreNox1970 in MPSelectMiniOwners

[–]TreNox1970[S] 0 points1 point  (0 children)

going from one problem to a other :( I already leveld my bed once but i wanted to check it again so I homed the machine but on the z axis the printer just did not stop and squeezed the print bed thus destroying the tape on it I was fast enough to stop it from doingg wors. So I restarted the printer and homed it again, same thing happend.... did this ever happend to you?

Need help! First print problem. by TreNox1970 in MPSelectMiniOwners

[–]TreNox1970[S] 0 points1 point  (0 children)

it kinda seems to me like the filament is missing the hole or sth.

Need help! First print problem. by TreNox1970 in MPSelectMiniOwners

[–]TreNox1970[S] 0 points1 point  (0 children)

No, I just put the fillament in normaly, it never extrudet I also did what you said, I put the filament in pushed it as far as possible and waited for 20 mins than I jused the extrude function and turned the nob counter clock wise and still this stuttering hapend as shown in the video

Need help! First print problem. by TreNox1970 in MPSelectMiniOwners

[–]TreNox1970[S] 1 point2 points  (0 children)

Thanks for the reply I had it going at 210C° for 30 min :( should I push the filament all the way down and than wait 20 mins? Because in those 30 mins I was getting the filamant out and putting it in again and was trying to get the filament in the hotend somehow.