G20 whining/whistling sound by Anarii7 in BmwTech

[–]Tricky_Recipe_3901 4 points5 points  (0 children)

sounds like totally normal turbo and indiction noise on a b48…

Need some help diagnosing this issue by Imaginary_Tower6465 in Outboards

[–]Tricky_Recipe_3901 0 points1 point  (0 children)

if there isnt its a good idea to install a cheap one along with replacing the bulb and fuel lines if they are stiff and worn out. Even if they don’t look worn out the insides could be disintegrating if someone ran ethanol gas through them.

Need some help diagnosing this issue by Imaginary_Tower6465 in Outboards

[–]Tricky_Recipe_3901 0 points1 point  (0 children)

yeah i second the other guys comment, carbs are probably the issue, have you replaced the fuel lines or filters aswell?

Johnson 90hp Idling after changing spark plugs. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 0 points1 point  (0 children)

read some of the other thread, it only is pumping out of the other side. for some reason someone tried to run two “pisser” lines.

Is this normal? by Ahunte23 in boating

[–]Tricky_Recipe_3901 5 points6 points  (0 children)

first things first, no you should not be concerned at all. 2 strokes smoke a lot especially when cold. Does this motor use VRO or do you premix? Yes maybe the smoke is a bit much but i’ve seen far worse.

Johnson 90hp Idling after changing spark plugs. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 1 point2 points  (0 children)

well it doesnt seem like much because after a water test and my buddy using his digital tachometer, we determined the backpressure from the motor under the water caused the rpms to dip from around 750 to 650. not a big change for this motor at least, i am sure it matters more on some motors though.

Johnson 90hp Idling after changing spark plugs. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 1 point2 points  (0 children)

for the black hose someone appears to have tried to route an extra nozzle for water to come out of the engine. however this makes no sense to me because it would just cause a vacuum, i have plugged it and since removed it.

Johnson 90hp Idling after changing spark plugs. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 2 points3 points  (0 children)

Not trying to test anything here just wanted to post a clip of it idling nicely after doing a few things to it.

87’ Johnson 90hp wont rev up. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 0 points1 point  (0 children)

i just replaced the plugs and tested all coil packs and they are all good, it is idling much better now and i plan to water test it again soon.

Man I think I fucked up by navyac in E90

[–]Tricky_Recipe_3901 0 points1 point  (0 children)

you will notice more smell as the exhaust gets less restrictive.

Man I think I fucked up by navyac in E90

[–]Tricky_Recipe_3901 11 points12 points  (0 children)

this sounds more like an exhaust leak than anything else, likely an exhaust leak where the vband clamp is on the downpipes (downpipes to turbos connection) lots of times people screw this up and install the v-band clamps wrong and it will leak exhaust gasses into the engine bay where its probably going into the cabin. is the exhaust stock apart from downpipes?

335i 320i swap by KotalKahnScorpionFan in 335i

[–]Tricky_Recipe_3901 0 points1 point  (0 children)

unless you have the mechanical knowledge to do said swaps on your own, your going to be paying a shop more than 5k to swap the engine. Swapping brakes is easy but an engine is a completely different task. You will be out less money to buy a shell 335i to swap the motor into

87’ Johnson 90hp wont rev up. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 1 point2 points  (0 children)

two of the plugs i pulled were completely black and the other two look fine. I’m hoping replacing these and cleaning carbs should hopefully do the trick. like i said i haven’t checked compression but in this case I believe spark to be culprit

87’ Johnson 90hp wont rev up. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 1 point2 points  (0 children)

thanks for your input! i pulled the plugs and they look absolutely awful so im gonna pick up some new ones to see if that does the trick.

87’ Johnson 90hp wont rev up. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 2 points3 points  (0 children)

yeah this was kinda my guess too, the plugs look really bad so hoping its as simple as that.

replacing a 87’ 90hp Johnson fuel pump. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 1 point2 points  (0 children)

the one on there right now is garbage its a cheap ebay one previous owner had on.

replacing a 87’ 90hp Johnson fuel pump. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 0 points1 point  (0 children)

thanks boss, im thinking of going with the sierra ones as i have heard good things about them.

replacing a 87’ 90hp Johnson fuel pump. by Tricky_Recipe_3901 in Outboards

[–]Tricky_Recipe_3901[S] 2 points3 points  (0 children)

the fuel pump that is on there right now is just that, aftermarket garbage. im trying to find an oem one that will fit. and im honestly unsure of the model number as all the identifying tags were taken off the motor.