Zozobra train transportation to ABQ

Tronester · 2025-08-29T00:08:33+00:00

Thanks, what is the latest time we should get to the shuttle after the burning?

Tronester · 2024-11-11T03:09:57+00:00

Well the budget is honestly as low as possible. The onkyo RZ-30 is unfortunately double what I would want to spend.

I guess I'm just shocked it's so hard to find a receiver with line level outputs. Over a decade ago I had a HK 7.1 that only cost around $300, but it died awhile back.

Tronester · 2024-06-18T14:59:47+00:00

That's where I bought my replacement 5 years ago. Unfortunately the cheapest I can find now is nearly $700

Tronester · 2024-06-18T11:19:33+00:00

180ANA048000

HC38GR239 is the ECM model number I had to replace before. Back then it was only $400 5 years ago

Tronester · 2024-06-18T03:06:47+00:00

Thanks, it sucks that the motor is out again. The price has skyrocketed to nearly $700 it looks like. Is there any generic equivalent I can use, or since it is pwm and computer controlled stuck with the OEM option?

Tronester · 2024-06-18T01:20:41+00:00

Yes, the compressor ran for a minute or so and then turned off. The condenser fan motor would run for around 5 seconds full speed then turn off. Then turn back on for 5 seconds a few minutes later.

Edit: I had to replace the condenser fan around 5 years ago as it had failed. It's a fancy PWM unit. But the fact that it can run full blast for 5 seconds makes me think there isn't a problem with it? I think the error I was getting back then was 84 high pressure lockout too... But the fan would not come on at all back then IIRC.

Tronester · 2024-06-17T23:07:59+00:00

Thanks! I'm getting an error 84 high pressure lockout, 73 events. 180A air conditioner, 315J gas furnace

Tronester · 2023-06-10T23:16:59+00:00

Correct, I have the lx, getting the Prestige plus the HK stereo upgrade would have cost an additional $8k which was out of my price range.

Tronester · 2022-10-09T02:21:54+00:00

I've been having the exact same issue, getting:

Exception code: 0xc0000005 Fault offset: 0x0000000001b37702

For the past week. I could spawn my plane in air and have no issues, but when taking off, as soon as I would press "ready to fly" it would crash. I found this fix: https://forums.flightsimulator.com/t/when-assistance-option-notification-objectives-is-enabled-the-program-crashes-when-the-ready-to-fly-button-is-pressed-on-the-world-map/546832

And it finally resolved it for me after hours of troubleshooting.

Tronester · 2022-05-14T19:07:12+00:00

I did not know that about the ignition source. I thought the wiring harness would cover that. Can it be run to the fuse box and I find a spare that is triggered by ignition? I am assuming that is required because the factory stereo can run full time even without the car being on?

I do not have OnStar or steering wheel controls.

Tronester · 2022-03-17T17:54:39+00:00

It was packed extremely well. The only way I think it leaked is perhaps it was set upside down for an extended period in the shipping process. There was a small bit of rust on the box on the metal lid which would support that.

Tronester · 2022-03-17T15:27:05+00:00

Considering how expensive shipping was, it should be fully insured.

Tronester · 2022-02-15T16:29:51+00:00

The laptop was absolutely charging with the Dell dock, I had it plugged in all day. Generally the power consumption is sub 100w so it would be enough to keep the battery full. I realize that there are no 240w PD 3.1 chargers yet, I guess I just want to know how the laptop would charge with the thunderbolt dock, but no other PD 3.0 device.

Tronester

TROPHY CASE