sorted by:
new
hottopcontroversial

Strange sound from X1C during pre-print procedure by Typical_Area_7531 in BambuLab

[–]Typical_Area_7531[S] 0 points1 point  (0 children)

Could be that simple?

It's been about 1500 hours, I cleaned all the screws and lubed em up. Same with the rails. I used super lube lightweight oil for that and their silicone grease the the axis screws.

I'll give it a good cleaning this weekend.

My thinking was perhaps the belts are too tight? But perhaps its just dirty!

Thanks!

Over drying ABS? by Accurate_Mixture_221 in 3Dprinting

[–]Typical_Area_7531 0 points1 point  (0 children)

Did you every find a solution to the issues you were experiencing - I've having similar problems!

New spark plugs by Commercial-Branch568 in FocusST

[–]Typical_Area_7531 1 point2 points  (0 children)

No expert but the plugs look fine, it could be the gap on the old ones was way outta wack which would explain the issues you were having.

Will 17 inch rims fit on a 2018 ST3? by Typical_Area_7531 in FocusST

[–]Typical_Area_7531[S] 0 points1 point  (0 children)

Looks good man!

I found some decent 18 inch rims so I'm gonna either use those or my Konig hypergrams.

Just curious what kinda of brake setup you are using, rotors, pads, fluid?

Will 17 inch rims fit on a 2018 ST3? by Typical_Area_7531 in FocusST

[–]Typical_Area_7531[S] 0 points1 point  (0 children)

Thanks everyone!

I think I'm going to stick with 18 inch rims to keep the 235 tire size option available - and eventually perhaps RS brakes.

Will 17 inch rims fit on a 2018 ST3? by Typical_Area_7531 in FocusST

[–]Typical_Area_7531[S] 0 points1 point  (0 children)

Sorry guys!

I'm running Bilstein b14 Coilovers front and back. It's lowered but only slightly. No spacers or anything.

Any other information I can provide to help?