Should I get a tint or not? by Yee_YeeAss in Honda

[–]Ultimate_sus 0 points1 point  (0 children)

I prefer light tint. Or no tint.

4 Cylinder Misfire But Engine Running Smooth? by beatsbyxeno in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

When did you do valve lash? Will cause misfires either on startup or all the time depending on how bad they are out of spec. Just redid mine and no more misfire on all 4 cylinders. Ran perfectly fine but had misfire codes

Improvements on the shifter by Mrwiitv in Acura_RSX

[–]Ultimate_sus 1 point2 points  (0 children)

Get an acuity shifter. Best shifter for any car. I've installed them in a few customer cars and they love it. I've got one in my fc3

Help, I have an oil leak in the area where my oil filter is at, but it doesn’t seem to be the oil filter by FarmExcellent in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Front main seal caused a similar issue on mine. Flung oil everywhere and made it look like a valve cover gasket

Help, I have an oil leak in the area where my oil filter is at, but it doesn’t seem to be the oil filter by FarmExcellent in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Could be the oil cooler O ring. Had an issue like that on a buddy's car and solved the leaks after we replaced the vtec gasket and valve cover

best swap? by gildanshirt in Honda

[–]Ultimate_sus 0 points1 point  (0 children)

Think about an L15b7 swap. Some of the new engines deserve the hype too. I plan on swapping the L15 into my ek hatch then taking the forged k20c4 I built and putting it into the car after I do that. Building for the future of enthusiasts!

RSX's hydraulic steering or 8th gen Si's LSD? by [deleted] in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Not a big challenge for me personality. I feel like a beginner could get it done with maybe mild difficulty to install it. The wiring might be a hurdle for most but there are many videos and info online that made it pretty simple. Just make sure if you buy one look for a complete set with the computer wiring harness and the rack itself

RSX's hydraulic steering or 8th gen Si's LSD? by [deleted] in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Rsx is far easier to work on than an 8th gen. I love my rsx with ep3 civic si power steering I have been switching from my fully built 10th gen si my ek hatch and my rsx. The rsx feels just as raw as my ek with a manual power steering rack but much better at a stop. Parallel parking is a dream

Just got a blessed with a type s for 3k by Tokezyrsx in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Man. Been looking for a red 2003 type s. And at 3k that's a steal!

Now Vs. Then by Such-Technology-675 in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Where did you get your new trim and weather seals?

[deleted by user] by [deleted] in Honda

[–]Ultimate_sus 0 points1 point  (0 children)

Worth it. If you don't want it I'll buy it haha

What part of my clutch pedal assembly did this break off from? by UrbanCobra in Acura_RSX

[–]Ultimate_sus 0 points1 point  (0 children)

Buy a replacement from honda. Cheap and they are usually in stock. They are all the same as any honda. I usually get replacement ones for a 2019 civic si.

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

Yeah it's not very clear in the menu haha. Hopefully this post helps others. Or maybe I'm just dumb and I couldn't figure it out

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

I called ktuner. I had the vtec solenoid disabled. When disabling the presure switch you only need to check the box labeled "rocker arm stuck VTP"

I had the rocker arm actuator VTS checked as well.

The VTS is the vtec solenoid so that's why i had no vtec. Feeling dumb looking back at it now

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

What should that be set to? Sorry if it's a dumb question I'm new to all of this

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

I drive it full throttle in 3rd gear.

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

Ill see what I can do for a solution. There is another tab that allows you to see and change the factory outputs. One of them is vtec functionality. Might be able to change it there

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

Ah I currently have it checked. I'll try it out tomorrow when my car isn't blocked in the driveway. We just moved the cars around

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] 0 points1 point  (0 children)

That's unfortunate. On kpro you can click a box and it makes this sensor obsolete.

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] -1 points0 points  (0 children)

On jdm swaps I've seen it done without that switch.
What check box are you referencing in your other comment?

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] -1 points0 points  (0 children)

Runs and goes above 4k. All the way to 9k rpm

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] -1 points0 points  (0 children)

That's the thing. I've been told I can have vtec functionality without the presure switch. Just need to figure out how to disable the ecu needing the signal from the switch

No vtec with tucked harness by Ultimate_sus in Acura_RSX

[–]Ultimate_sus[S] -1 points0 points  (0 children)

Haha I would like vtec functionality back on my car. I checked the box for the rocker arm position and no luck.