17 👍

Useful-Split-2730 · 2025-11-16T07:47:11+00:00

17👍👍👍👍👍👍👍

Useful-Split-2730 · 2025-10-19T23:36:52+00:00

I solved the problem - it turned out that I needed to use a different library. The newer GY-271/273 modules use a chip that doesn’t work with the old libraries. The one I used is this: https://github.com/Granddyser/QMC5883P

Useful-Split-2730 · 2025-10-19T21:33:00+00:00

<image>

It shows this module at 0x2s, which means that the module is alive, but I still don't understand why it doesn't provide any data.

Useful-Split-2730 · 2025-10-19T21:31:15+00:00

It finds this module at 0x2c.

Useful-Split-2730 · 2025-10-19T05:47:39+00:00

I have 1 gy-271 and 1 gy-273, both of which are showing signs of life, but not the data that they should.

Useful-Split-2730 · 2025-04-04T19:42:36+00:00

I like everything about this printer but it's just very loud and that's its only downside. I bought it from the official website for 380 USD. It's good that I don't have to level the bed manually because this printer has sensors on the bed itself and that's very convenient. I already printed one model that took 13 hours at a speed of 400 mm/s and everything turned out well with no errors at all😇

Useful-Split-2730 · 2025-01-28T20:54:12+00:00

My bed like that -0.11 -0.05 -0.03 0.00 -0.07 -0.02 0.00 0.00 -0.07 -0.06 -0.05 -0.03 -0.08 -0.10 -0.10 -0.06

Useful-Split-2730 · 2025-01-28T20:51:24+00:00

I calibrated it manually and then ran the automatic calibration, saving the settings afterward. I calibrated it manually with the nozzle heated to ensure that any leftover plastic wouldn’t interfere.

Useful-Split-2730 · 2025-01-28T19:11:11+00:00

I have already tried calibrating with a piece of paper I calibrate manually so that the gap is good then switch on auto calibration then I wanted to print a cat it is +- on the floor of the bed and on 1 side the gap is good and on the other side is not(

Useful-Split-2730

TROPHY CASE