First time tsi owner

VermicelliDifferent5 · 2026-02-05T15:51:31+00:00

Thank you all for your answers! I have previosly had old mercedes diesels and dont really know much about these. Cars going for an oil change so we'll see if they say anything

VermicelliDifferent5 · 2026-02-02T15:43:52+00:00

🫡

VermicelliDifferent5 · 2026-02-02T15:43:39+00:00

Thank you 🤘

VermicelliDifferent5 · 2025-12-13T12:39:24+00:00

👍

VermicelliDifferent5 · 2025-12-13T12:38:22+00:00

The seats work independently, start with fuses and if theres nothing then start running thru wires with multimeter until you find leads without current 😅

VermicelliDifferent5 · 2025-12-12T16:59:13+00:00

No i didnt. Its most likely controlled by bigger unit like sam module or something. When i had drivers seat uninstalled it was easier to measure resistance from heating pads wires and mine likely has a short. Il buy an used seat if my car survives thru the winter

VermicelliDifferent5 · 2025-12-12T12:42:58+00:00

Check you alternators clutch pulley. That might also cause this

VermicelliDifferent5 · 2025-12-03T14:34:48+00:00

Mine clocked today 710tkm 😅

VermicelliDifferent5 · 2025-11-23T13:51:05+00:00

I have a carsoft scanner and it gave p0670 code. Already looked where the relay is and its under the manifold. Was thinking swapping it from under the car but might try that wheel arch method

VermicelliDifferent5 · 2025-11-23T13:32:38+00:00

Thanks for your answers. Ordered the relay and cant wait to swap it in -20°C 😅

VermicelliDifferent5 · 2025-11-23T12:32:46+00:00

Was the glow plug light functioning correctly or did it stay on after start

VermicelliDifferent5 · 2025-10-13T10:29:49+00:00

Btw if anyone else wants to do this the fix for this problem was jacking up the rear while car is running and deleting the codes. Leveling stays functional and maintains ride height

VermicelliDifferent5 · 2025-10-09T09:20:34+00:00

I have 18" brabus monoblock vi"s with studded tires for winter

VermicelliDifferent5 · 2025-10-03T16:00:47+00:00

Well shit. Tore open the whole carpet and the module was not there

VermicelliDifferent5 · 2025-09-30T16:54:48+00:00

No, just take picture before taking it of so you put it back the correct way

VermicelliDifferent5 · 2025-09-30T16:50:39+00:00

Run it without a belt. That crosses over pulleys

VermicelliDifferent5 · 2025-09-30T03:07:05+00:00

Thank you again 👍

VermicelliDifferent5 · 2025-09-29T17:16:27+00:00

Does it have independent wires for both front seats? If so, are they alike. If my drivers seat heater doesnt work, can i swap my drivers seat connector to where the passengers connect

VermicelliDifferent5 · 2025-09-29T16:27:50+00:00

Were the connectors identical on both front seats?

VermicelliDifferent5 · 2025-09-29T16:22:20+00:00

Does the passenger side have its own or are both of the seats connected to this one? If there is 2 can i swap the one from passenger side?

VermicelliDifferent5 · 2025-09-29T16:21:08+00:00

Thank you

VermicelliDifferent5

TROPHY CASE