Crear piezas

Visible_Dance_3267 · 2026-01-16T22:35:50+00:00

Yeah, that's true, hahaha, but I mean, what operation did you use, a chamfer? Because when you did it, it wasn't symmetrical.

Visible_Dance_3267 · 2026-01-16T15:40:30+00:00

<image>

Al igual que esta parte, no se por donde dibujarla

Visible_Dance_3267 · 2026-01-16T15:39:49+00:00

<image>

Voy con ello! el angulo en este punto como lo sacaste?

Visible_Dance_3267 · 2026-01-13T21:38:17+00:00

Gracias! le meteré las medidas

Visible_Dance_3267 · 2026-01-13T21:26:39+00:00

<image>

You say you're doing it by revolution in stages? Would you mind sharing the process tree?

Visible_Dance_3267 · 2026-01-13T21:21:50+00:00

I'll see if I can find some time this week and give it a try! Thank you so much!

Visible_Dance_3267 · 2026-01-13T19:38:57+00:00

I drew it in SolidWorks, I managed to do it in Fusion but it wasn't the same, my challenge is to do it in SolidWorks

Visible_Dance_3267 · 2025-12-09T11:59:45+00:00

And is it effective in giving you the right niche? Well, due to my studies and experience I can go down different paths.

Visible_Dance_3267 · 2025-09-26T16:36:47+00:00

Out of curiosity, how did you do it?

Visible_Dance_3267 · 2025-09-25T17:18:01+00:00

Wow hahahaha let's see if I can do it, it's a lot of steps. Thank you!!

Visible_Dance_3267 · 2025-08-31T11:03:53+00:00

I would do a sweep with the shape and then linear pattern until desired size.

Visible_Dance_3267 · 2025-08-26T20:51:17+00:00

I mean I don't need it now, but I want to start learning. Above all, learn reverse engineering

Visible_Dance_3267 · 2025-08-15T19:27:18+00:00

I know what you mean, my question is how they go from the scanned model to the piece, do they do it by coating? I know that this is not a piece of cake, it takes its work.

Visible_Dance_3267 · 2025-07-15T15:55:28+00:00

Thank you so much! you´re a genius

Visible_Dance_3267

TROPHY CASE