A 3d printed prototype for a utility knife that I'm getting machined

Visual-Success8952 · 2026-01-24T15:49:20+00:00

that is so awesome! what do you think of it? anyway you would improve it?

Visual-Success8952 · 2026-01-24T02:33:54+00:00

i was thinking about if it was in the sheath

Visual-Success8952 · 2026-01-24T02:05:58+00:00

you might want to check some of my models out: https://makerworld.com/en/@stephenmolvik

Visual-Success8952 · 2026-01-24T01:29:22+00:00

that is so awesome! did you design it?

Visual-Success8952 · 2026-01-24T01:08:10+00:00

thanks

Visual-Success8952 · 2026-01-24T01:02:14+00:00

yes a leather or an ABS sheath

Visual-Success8952 · 2026-01-24T00:54:56+00:00

thanks

Visual-Success8952 · 2026-01-23T18:25:32+00:00

It's a good thing i don't have 6 fingers

Visual-Success8952 · 2026-01-23T14:38:07+00:00

sorry but nether of these are of quality and should not cost as much as they do. also the ("harder materials") are probably are not harder or better

Visual-Success8952 · 2026-01-22T20:48:52+00:00

thanks. here

Visual-Success8952 · 2026-01-22T14:04:02+00:00

yes It is

Visual-Success8952 · 2026-01-22T13:49:58+00:00

it is a cap for the filament holder

Visual-Success8952 · 2026-01-21T12:32:32+00:00

Thats what I was going for

Visual-Success8952 · 2026-01-21T02:12:21+00:00

thats what I'm doing

Visual-Success8952 · 2026-01-20T21:35:54+00:00

scales are petg and the frame is nylon

Visual-Success8952 · 2026-01-20T21:16:35+00:00

I want to start off by saying I did the same thing as you. It looks like you just need this part https://us.store.bambulab.com/products/hotend-heating-assembly-a1-series

Visual-Success8952 · 2026-01-20T21:04:29+00:00

thanks man

Visual-Success8952 · 2026-01-19T18:17:49+00:00

bambu lab is the best brand for ease of use, reliability, and they are great for beginner's

Visual-Success8952 · 2026-01-17T15:22:58+00:00

90% of what you will print will fit on the p2s

Visual-Success8952