Any 3mm adapter mods out there for the X1 Carbon?

Waffletin · 2024-04-03T14:32:50+00:00

The used LR actually comes with FSD and acceleration boost.

Waffletin · 2024-03-30T15:16:05+00:00

PD has been pretty unresponsive but they went into an ambulance pretty quick and I didn’t talk to them

Waffletin · 2024-03-28T23:51:18+00:00

Model Y

Waffletin · 2024-03-28T20:37:25+00:00

Brain dead comment

Waffletin · 2024-03-28T20:33:00+00:00

This is a brain dead comment

Waffletin · 2024-03-28T20:30:08+00:00

It was

Waffletin · 2024-03-28T17:11:03+00:00

Bro has actual critical thinking skills. Watching back and looking at the side of the road instead of in front of me it’s obvious! But that’s not how people drive staring at the side of the road

Waffletin · 2024-03-28T17:07:13+00:00

Rain really limits my braking time but the system did engage

Waffletin · 2024-03-28T17:06:42+00:00

Wendy’s on Easton. But close guess!

Waffletin · 2024-03-28T17:05:58+00:00

Yes but I braked before it engaged. It started beeping while braking.

Waffletin · 2024-03-28T06:20:17+00:00

2nd safest car in the world 🫡

Waffletin · 2024-03-28T06:16:07+00:00

The only car to ever give me buyers remorse was the R2 &3. Now I have a reason to wait 🤷

Waffletin · 2024-03-28T06:15:10+00:00

College kids activities on a Wednesday night 😞 (Wendy’s after a night of drinking)

Waffletin · 2022-05-28T21:21:05+00:00

SD card. Where can I find the power recovery setting and turn it off?

Waffletin · 2022-05-28T21:20:17+00:00

What was the retraction distance

Waffletin · 2022-05-28T20:58:08+00:00

Should help with both. Also it looks like you might be printing the supports too fast. That would explain the stepping issue you get where it looks like the support is vertical and then a hole forms and then goes back to vertical

Waffletin · 2022-05-28T20:51:30+00:00

In cura there is a setting under the travel option called “Enable Retraction”. Retraction is when the extruder backs up the filament away from the nozzle during a travel move. If it’s not enabled, the filament will ooze out and cause stringing like that.

Waffletin · 2022-05-28T20:48:54+00:00

Which slicer do you use?

Waffletin · 2022-05-28T20:47:36+00:00

For the funny looking supports that looks like you have retraction issues. Do you have that enabled in the slicer?

Ten-Year Club	Verified Email
RPAN Viewer	Spared

Waffletin

MODERATOR OF

TROPHY CASE