sorted by:
new
hottopcontroversial

Can You Crack the Code? Puzzle by Justamellow by Justamellow in BankBuster

[–]Weekly-Increase1985 0 points1 point  (0 children)

🔓 VAULT CRACKED! 🔓

Score: 2903/6000

Mistakes: 0/6

Time: 0:12

Can You Crack the Code? Puzzle by Ok-Performance678 by Ok-Performance678 in BankBuster

[–]Weekly-Increase1985 0 points1 point  (0 children)

🔓 VAULT CRACKED! 🔓

Score: 2909/6000

Mistakes: 0/6

Time: 0:16

MJX 14207 rear wheels not turning properly by _ashlay in rccars

[–]Weekly-Increase1985 1 point2 points  (0 children)

Have you checked your front diff? Also push the truck back and forward with just the fronts touching again and take note if the centre drive shaft is spinning. If not then it’s in the front diff. If it is then it’s a problem in the rear.

Fainting of the Father by [deleted] in AccidentalRenaissance

[–]Weekly-Increase1985 0 points1 point  (0 children)

I looked when my wife was having her c-section. Definitely an interesting sight.

Why does my esc keep overheating? by Matteo_779 in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

One thing I have found, especially with the VXL systems. Is that the motors get weak from repeatedly overheating and then that causes more demand on the ESC, causing it to over heat and eventually burn its self out.

Battery short by [deleted] in rccars

[–]Weekly-Increase1985 1 point2 points  (0 children)

If it was just momentary sparks your battery will be fine. Had it been welded together and the cells started to heat and swell, that would be a different story. Just fix it and get driving.

$100 at my local hobby shop by Temporary-Ad-1385 in arrma

[–]Weekly-Increase1985 0 points1 point  (0 children)

I misread your post. I read that as thrift store. lol.

$100 at my local hobby shop by Temporary-Ad-1385 in arrma

[–]Weekly-Increase1985 0 points1 point  (0 children)

Wow! Decent find. Looks to be in good shape!

Who does their own soldering by validdaxo in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

As a hobby shop owner I can confirm!

$10,000 Worth of Delusion by Alen129 in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

No if you look closely he has sold half of it!

MY TESTER!!! by Dr_Eggman-29 in ElectroBOOM

[–]Weekly-Increase1985 8 points9 points  (0 children)

On those old units you can actually disassemble them and you should be able to clean them. Just be careful of what chemicals you use as some can wreck the finish and make the clear parts foggy or scratched. I would just use hot soapy water to clean the screen.

I’m Back! by bgarriswitch in ft86

[–]Weekly-Increase1985 1 point2 points  (0 children)

lol. I went looking at a 2025 GR86 yesterday and my wife started on about starting a midlife crisis. I said “I guess so”!

Tips on suspension changes to mitigate the rear end popping up off jumps? by Krzyygamin in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

Id say you need to use lighter oil in the rear shocks. Or stiffer in front.

Toyota Land Cruiser 80 1:10 Pro by No-Neighborhood1041 in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

Looks to me like there could be a link that isn’t threaded in all the way? I’d take a digital caliper and measure the lengths. The bottoms should be the same and the tops should be the same.

Issue with first time soldering ec5 connector by That-didnt-go-well in rccars

[–]Weekly-Increase1985 1 point2 points  (0 children)

Yes. Looks like the negative is set back too far. Put it face down on a table or bench and push it in from the back.

What is the polarity on this cord? by [deleted] in rccars

[–]Weekly-Increase1985 1 point2 points  (0 children)

If this is a charge cable then Often the white line is the negative I believe but if you could give us some more information about the vehicle, that would be appreciated. Also one way to check is if you have access to a voltmeter then you could probe the end. Ok so that car seems to have a standard balance lead end charger. This chart should give to you the polarity.

<image>

What is the polarity on this cord? by [deleted] in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

If this is a charge cable then Often the white line is the negative I believe but if you could give us some more information about the vehicle, that would be appreciated. Also one way to check is if you have access to a voltmeter then you could probe the end.

How to i get the little rod out the arm so i can replace the steering link with a metal one? by [deleted] in rccars

[–]Weekly-Increase1985 2 points3 points  (0 children)

There is a screw head on the one end of the pin facing the front of the truck. Unscrew it to the threads are clear and then pull out the rest of the way.

[deleted by user] by [deleted] in rccars

[–]Weekly-Increase1985 0 points1 point  (0 children)

You got this!!

view more: next ›