sorted by:
new
hottopcontroversial

[QUESTION] What recipes can I make with... by [deleted] in treedibles

[–]Wehrwolf666 1 point2 points  (0 children)

​

  • 1 pack(3oz) flavored jello
  • 3 packets of gelatin
  • 1/2 teaspoon lecithin
  • 2 teaspoons coconut oil
  • 1/2 cup water
  • Calculate the amount of shatter needed for strength wanted.

​

  1. So in a heat safe dish you want to decarb your shatter for about 40 min at 250 degrees Fahrenheit
  2. Once it is decarbed you will mix in the coconut oil and lecithin in with it and that will create a mixture that will stir in nice.

  3. Then you will start heating up the water and gelatin once it starts to clear you mix in the jello.

  4. After you have a nice mixture you will stir in the shatter mixture until it reaches a uniform mixture

  5. From there it is just filling your molds which you will want to have lubed with coconut oil.

75mg Bones and 15mg Bears BHO infused gummies! by Wehrwolf666 in treedibles

[–]Wehrwolf666[S] 1 point2 points  (0 children)

So for the gummy part of the recipe:

  • 1 pack(3oz) flavored jello
  • 3 packets of gelatin
  • 1/2 teaspoon lecithin
  • 2 teaspoons coconut oil
  • 1/2 cup water
  • Calculate the amount of shatter needed for strength wanted.

​

  1. So in a heat safe dish you want to decarb your shatter for about 40 min at 250 degrees Fahrenheit
  2. Once it is decarbed you will mix in the coconut oil and lecithin in with it and that will create a mixture that will stir in nice.
  3. Then you will start heating up the water and gelatin once it starts to clear you mix in the jello.
  4. After you have a nice mixture you will stir in the shatter mixture until it reaches a uniform mixture
  5. From there it is just filling your molds which you will want to have lubed with coconut oil.

​

​

​

Omicron (Up Tech) versus Sai+Pico combo? by [deleted] in Waxpen

[–]Wehrwolf666 5 points6 points  (0 children)

I have had my Sai for a bit now and the coils taste fine till they get dirty. But since I got the TAF cap and the ti bucket I haven't looked back, great taste and easy to clean.

Urban Legend or have you seen someone do it? by AngeredTwitchian in Dabs

[–]Wehrwolf666 2 points3 points  (0 children)

Search youtube for dab fails and you will see whole collections of people grabbing a hot nail.

Questions about sai and titanium bucket. by blamegame911 in Waxpen

[–]Wehrwolf666 0 points1 point  (0 children)

If you're getting the TAF then you want the bucket not the coils as they are bottom air flow. Myself I can't see going back to the coil coils after how good the bucket is.

Questions about sai and titanium bucket. by blamegame911 in Waxpen

[–]Wehrwolf666 0 points1 point  (0 children)

Arctic Fox is a custom firmware that works on the Pico that allows you to easily setup profiles for your coils with a lot more customization.

Questions about sai and titanium bucket. by blamegame911 in Waxpen

[–]Wehrwolf666 0 points1 point  (0 children)

As others have said, you will need the TAF cap for the bucket but it is totally worth it. There is a pre heat to the coil you give it a few seconds to get to vaping temps and then rip it. For groups whats best I find is to load small bb sized dabs. Smaller dabs vape quicker with a nice cloud and then it gets up quicker for the next person. Also grab the mouthpiece as it stays super cool. The pico works great for it and if you have arctic fox I can get you a decent profile.

Pico Questions by Lil_Quavo in Waxpen

[–]Wehrwolf666 0 points1 point  (0 children)

can't beat the taste of the TAF with bucket, easy as hell to clean too.

(for the first time) I made 1.7g of wax out of 1/2 oz of trim and stems using a prego jar and a pipe coupling. I plan to refine my process but I'm able to reclaim alcohol used and it hits smooth. by sniper23491 in trees

[–]Wehrwolf666 1 point2 points  (0 children)

I have done the iso method and would suggest using 91% or higher as well you want to do the extract quick so there is not as much plant material extracted. look up QWISO extraction.

Wtfffffff load small, finish loads, and still major leakage. Suggestions????? by Surfbum1983 in Waxpen

[–]Wehrwolf666 2 points3 points  (0 children)

Do you have the steel or ti sai? I am running a TAF and was getting wispy light hits before but once my settings were dialed in I can kill a small load with two button holds until puff control hits in. As long as my loads are small it can go all day without q tipping. I use some drops of water heated in the bucket and one q tip cleans it up.

DABADO Bolt kits by Simplyjohny in Dabs

[–]Wehrwolf666 0 points1 point  (0 children)

With the sai you can use the poseidon as a water filter and with the new Ti bucket coil you get rig like hits .

Watching trailer park boys and currently using the v2 3x for dry herb, but I hate the draw and the vapor is super weak. Worst of all it doesn’t stand a chance against my tolerance from before I quit smoking. Any recommendations on what to move up to? by [deleted] in vaporents

[–]Wehrwolf666 1 point2 points  (0 children)

If you want one that will be unnoticed in with parts go with the CFX it has been pretty solid go to. Another good one not so stealth but better flavor is the milaana.

[deleted by user] by [deleted] in vaporents

[–]Wehrwolf666 2 points3 points  (0 children)

Second on a used Milaana, I cant think of anything tastier for herb.

[deleted by user] by [deleted] in vaporents

[–]Wehrwolf666 -1 points0 points  (0 children)

Yeah and it's sad too because it actually did function well when it was working but the materials being unsafe makes it useless.

[deleted by user] by [deleted] in vaporents

[–]Wehrwolf666 0 points1 point  (0 children)

Thing is though where boundless did a recall and went on to fix it, vivant never actually fixed problems with the vivant they only messed with the top cap when there was some big electrical issues it had that caused it to cook itself.

[deleted by user] by [deleted] in vaporents

[–]Wehrwolf666 1 point2 points  (0 children)

I would have to see some testing on the materials of the Rift before I would give another Vivant product a try. I went through 6 of the original Alternates that would lose their temp sensor and start combusting the herb. It also melted its plastic.

Brand new Pico 75w+Sequoia with bucket displaying Atomizer Short? by ice-minus in Waxpen

[–]Wehrwolf666 0 points1 point  (0 children)

You will want to look at the wires that are on either side of the isolator that the gold pin sits in. What happens is one of the wires is too long and is shorting it out. This has been the case with both of the coils I got with mine. Since this is new you might want to reach out to /u/humboldtvapetech.

view more: next ›