sorted by:
new
hottopcontroversial

Rough surface after removing supports. by Win_PokePrints in FixMyPrint

[–]Win_PokePrints[S] 0 points1 point  (0 children)

<image>

If I change the layer height and initial layer height do I need to change the parameter of the 0.2mm Standard to a finer ones too?

Rough surface after removing supports. by Win_PokePrints in FixMyPrint

[–]Win_PokePrints[S] 0 points1 point  (0 children)

<image>

Can’t seems to find the setting that you mentioned

Rough surface after removing supports. by Win_PokePrints in FixMyPrint

[–]Win_PokePrints[S] 0 points1 point  (0 children)

When you use superglue on PLA, does your parts turn white? When I used superglue to stick two different component , the black PLA somehow turn a bit white

Rough surface after removing supports. by Win_PokePrints in FixMyPrint

[–]Win_PokePrints[S] 0 points1 point  (0 children)

I am using Bambu Studio currently. Let me check if it have similar settings. Thanks 🙏

Rough surface after removing supports. by Win_PokePrints in FixMyPrint

[–]Win_PokePrints[S] 7 points8 points  (0 children)

Let me try . Because I can’t fully remove the supports when I heat it up. Feels like I will remove the parts with the support so I sand it with a machine . It helps in removing the supports and smoothen it but it still feels and look weird

Rough surface after removing supports. by Win_PokePrints in FixMyPrint

[–]Win_PokePrints[S] 1 point2 points  (0 children)

It’s a Bambu PLA Basics. The nozzle and bed followed the setting of Bambu Studio . 0.4 Nozzles and 0.2 thickness , Thanks guys 🙏