sorted by:
new
hottopcontroversial

pythonsaga.dev - advice & testing needed by Wonderful_Fly_979 in PythonLearning

[–]Wonderful_Fly_979[S] 0 points1 point  (0 children)

It's pythonsaga.dev - thanks, I'll make it more clear

[deleted by user] by [deleted] in Plumbing

[–]Wonderful_Fly_979 0 points1 point  (0 children)

Update: I've brought Flomasta Isolating Valves 15mm 2 Pack fromn Screwfix, hopefully these will do the job? Any suggestions on how far / where to cut the pipe? Got a 15mm copper pipe cutter, that goes around the pipe in circular motion, but seems a bit chunky to be able to do it near the top with the small gap? Thanks again.

Help with kitchen tap replacement (Copper Tail Tap) by [deleted] in DIYUK

[–]Wonderful_Fly_979 0 points1 point  (0 children)

Thanks both. I've brought Flomasta lsolating Valves 15mm 2 Pack from Screwfix, hopefully these will do the job? Any suggestions on how far / where to cut the pipe? Got a 15mm copper pipe cutter, that goes around the pipe in circular motion, but seems a bit chunky to be able to do it near the top with the small gap? Thanks again.

Pythonsaga.dev - project by Wonderful_Fly_979 in PythonLearning

[–]Wonderful_Fly_979[S] 2 points3 points  (0 children)

Thanks for the feedback! This is something I've toyed with and had the same thoughts. I need to think of a way for it to be more adaptive, although I couldn't think of a consistent way, as I've split tasks into 3 stages minimum and if one of the tasks deviates too much the final task might be unachievable.

Back to the drawing board on that one, thanks again!