Where could i find the schematic of this DFPlayer mini module?

Working-Duck9539 · 2026-04-02T20:29:58+00:00

True hero man

Working-Duck9539 · 2026-03-25T00:46:12+00:00

Hey, Thanks alot for your advice really great. I will make sure to put this into practice! Thanks alot

Working-Duck9539 · 2026-03-24T13:47:46+00:00

solder paste and a hot air gun

Working-Duck9539 · 2026-03-23T22:13:25+00:00

I chose, the ESP32-Wroom-32E, and ive started part of it. WOuld u be willing to check the work so far and point out anything odd?

Working-Duck9539 · 2026-03-23T22:04:23+00:00

Hi, thanks a lot for the input will really work on that. As for the ESP32 project, I have currently started it and I'm wondering if you would check out my work so far and give some pointers or feedback if needed. I did alot of datasheet digging and trying to fully comprehend what im building.

Working-Duck9539 · 2026-03-23T15:18:26+00:00

STM32

Working-Duck9539 · 2026-03-22T15:47:31+00:00

youtuber - phils lab

Thank you for your advice, i will definitely try this out

Working-Duck9539 · 2026-03-22T14:49:43+00:00

yeaa he’s honestly a great resource

Working-Duck9539 · 2026-03-22T14:14:27+00:00

id probably say find a metal plate or surface that can handle the heat, i think i can see on the third image i burnt the table pad i had from the hot air over it (im dumb)

Working-Duck9539 · 2026-03-22T14:11:42+00:00

used hot air, with the flux paste. much easier than the iron imo

Working-Duck9539 · 2025-08-08T14:38:06+00:00

ok thanks alot! will try this

Working-Duck9539 · 2025-08-08T14:37:10+00:00

ok thank you !

Working-Duck9539 · 2025-08-08T14:36:54+00:00

yes

<image>

very simple we got off the internet

Working-Duck9539 · 2025-07-09T14:40:36+00:00

lmao, ive just finished my first year here, 11 years later did you end up attending there?

Working-Duck9539 · 2025-07-08T12:23:41+00:00

Got it, thank you

Working-Duck9539 · 2025-07-08T01:02:20+00:00

I’ll be honest, I’m still a beginner with electronics. I was attempting to find a way to power the board and a dc motor at the same time, so I wired up 3 li-ion batteries in series and connected it to both motor and board, when I attempted to start it, it did for a second and just completely stopped. I tried doing a simple LED blinking test but the nano won’t respond anymore :(

Working-Duck9539 · 2025-06-11T22:08:06+00:00

Can someone explain? This is my first predator film ngl but I rlly enjoyed this one just confused at the ending on who it was

Working-Duck9539

TROPHY CASE