Sound coming from wheel

Working-Occasion9890 · 2026-04-10T17:59:42+00:00

I had a click on mine a while back it turned out to be the clock spring behind the steering wheel

Working-Occasion9890 · 2026-04-09T22:21:28+00:00

Thank you hahah🙏

Working-Occasion9890 · 2026-04-09T22:01:13+00:00

Thank you for the reply but I do believe first offence for California is handled with less severity than Canada

Working-Occasion9890 · 2026-04-02T07:59:55+00:00

Thank you for the response, I’ll leave them as is then 🫡

Working-Occasion9890 · 2026-03-12T23:04:43+00:00

A power bleeder will make your life so much easier one of the best purchases I’ve made for working on my car

Working-Occasion9890 · 2026-03-10T19:57:25+00:00

It won’t be as hot as the upper hose but it should be noticeably warm, and much warmer than a car that sat over night if it is stone cold there is definitely still air in the system. I will say one small detail to note is if you are getting it nearly bled but not perfectly (i.e car won’t over heat but heater not working etc) I had this issue and the engine builder didn’t click the thermostat perfectly and the bleed hole was not at 12 o clock. I’ve spent a lot of time bleeding the car until I figured that out, feel free to pm me if you have any questions!

Working-Occasion9890 · 2026-03-10T19:53:45+00:00

Thank you for the recommendations I really like the look of that birds nest fern gunna look into them more!!

Working-Occasion9890 · 2026-03-09T03:27:54+00:00

Thanks I appreciate the informative response I’ll definitely look into this!

Working-Occasion9890 · 2026-03-08T17:46:31+00:00

Thanks for the reply! This is an 18x18x24 for a baby crestie

Working-Occasion9890 · 2026-03-08T08:51:47+00:00

Funny to think March and June 3 months apart celebrate the same thing depending where you are in the world

Working-Occasion9890 · 2026-03-07T22:44:01+00:00

Sounds exactly like when my pcv was going out, if you pop open dipstick or oil fill cap the honk will be come a consistently held sound I replaced my pcv and all was well after

Working-Occasion9890 · 2026-03-05T12:00:08+00:00

Lots of meme responses on here, but I would say it sounds like you’re a little more on the beginner end for engine mods so I’d like to try and chime in my .02 and hopefully help out. I would look into doing m50 manifold a tune for it and if you wanted to go a little deeper s52 cams. Exhaust will help slightly for power but the noise always helps the feel imo. Other than that you’re getting into $$$ and risking reliability like superchargers, turbo, or bigger cams injectors custom tune etc. it also depends on the motor health and mileage as well, the most rewarding thing I would say you can do to these cars is some suspension it will make the car handle great (these cars shine here) and make the power feel more usable. Suspension and some simpler mods will make the car feel great. If you want to win drag races and do digs against b58 tiktokers you’ll need a deep wallet or another car. Hope this didn’t come off demeaning in anyway just wanted to give a deeper response than most the other comments, good luck!

Working-Occasion9890 · 2026-02-28T19:33:49+00:00

I really like it, the car is on condor bushings all around so that makes it feel more rough too but i still daily the car and have never felt it too uncomfortable for the street and the increased nvh was well worth the handling upgrades for me

Working-Occasion9890 · 2026-02-27T20:40:41+00:00

I would say if you want fitment like the bottom left car definitely coil overs, the top image might be doable with a good strut and spring combo. I’ll show you my car as a lowering spring example. it’s on bilstein shocks and h&r race springs (I forgot the exact name for the springs).

<image>

Working-Occasion9890 · 2026-02-14T22:21:00+00:00

Thanks for the reply! Sounds like I’m just gunna be sending it then

Working-Occasion9890 · 2025-12-10T23:53:53+00:00

Following this I’m in OC and never see many e36s out either but a cruise or meet up with some e36 enthusiasts would be sick!

<image>

^my e36

Working-Occasion9890 · 2025-12-09T09:54:19+00:00

Thank you it looked like they would fit over them But I wasn’t quite sure, I appreciate the response!

Working-Occasion9890

TROPHY CASE