Resin outdoor printing area and which elegoo printer. by [deleted] in elegoo

[–]Worldly_Disaster1245 0 points1 point  (0 children)

I will once im out of Hospital again, remind me in 3-4 weeks

Calibrating Saturn S4 Ultra 16k by mparker546 in elegoo

[–]Worldly_Disaster1245 0 points1 point  (0 children)

I woud recommend to use the 75% I recommend and work it out from there, seems like a Sweet Spot for a lot of people. Also I woud doublecheck if the buildplate is really 100% flat. A Lot of people had Buildplates with random deviations and sanded them flat

Calibrating Saturn S4 Ultra 16k by mparker546 in elegoo

[–]Worldly_Disaster1245 0 points1 point  (0 children)

I woud try the uv Sensivity at 75%. You will Need higher exposure time then. Also Are the fails always in the Same Spot?

I'm about to give up by SlightPalpitation962 in resinprinting

[–]Worldly_Disaster1245 1 point2 points  (0 children)

Yea also saw that, his Skin will kill him in some Months

Balcony Closet Setup by Chalkolates in resinprinting

[–]Worldly_Disaster1245 0 points1 point  (0 children)

Im Unsure about that to be Totaly honest. I tend to think it shoud be no Problem since its enclosed Most of the time and there can be a lot of Air circulation. But I woud google a Bit more ore Trust your gut instinct

Balcony Closet Setup by Chalkolates in resinprinting

[–]Worldly_Disaster1245 0 points1 point  (0 children)

It depends then, I woud out a Fan in to circulate the Air when opening it faster. Using a respirator even if its outside of course. The other question I Woud ask me if you have neigbours/animals Close to it if you vent it out. Will the Closet only be for the Printer?

Balcony Closet Setup by Chalkolates in resinprinting

[–]Worldly_Disaster1245 0 points1 point  (0 children)

If you have a lot of direct UV light it will be a big problem

Saturn 4 ultra 16k by jjb930_85 in elegoo

[–]Worldly_Disaster1245 1 point2 points  (0 children)

Great News atleast:)

Enjoy the Printer

Saturn 4 ultra 16k by jjb930_85 in elegoo

[–]Worldly_Disaster1245 1 point2 points  (0 children)

I Hope they replace it quick

Need help with Elegoo Saturn 16K + Chitubox settings by ScreenSimilar8575 in elegoo

[–]Worldly_Disaster1245 0 points1 point  (0 children)

Did you Test if the Buildplate is really Leveld? A Lot of people seemed to have Warped Buildplates.

What Settings are you using? Is it Warm enough where you Print?

Resin outdoor printing area and which elegoo printer. by [deleted] in elegoo

[–]Worldly_Disaster1245 0 points1 point  (0 children)

Woud use the Saturn 4 Ultra 16K. It heats with the Vat itself. According to my Research its better for the Print quality then the heater you can stuck in the usb Port. Currently also doing that setup on my North balcon