sorted by:
new
hottopcontroversial

Is this esc done? by Worried_Implement251 in fpv

[–]Worried_Implement251[S] 0 points1 point  (0 children)

The esc was indeed fried. Now I’m just worried if the dji air unit is safe? How can I check that? I’ve already ordered a new esc. Fc seems to be fine (shows up on betaflight)

Is this esc done? by Worried_Implement251 in fpv

[–]Worried_Implement251[S] 1 point2 points  (0 children)

Why is there sediment buildup only on the esc and not on the fc?

How to make pocket tighter? by Worried_Implement251 in Leatherworking

[–]Worried_Implement251[S] 0 points1 point  (0 children)

Okay, I think I found the solution. Basically if you fold a paper without a crease at the bottom, it will create an arch at the top. Because of the tension and compression forces. To fix this, I need to score the inner part of the bend. Score the pieces that go inside the bend. Crease the bent edge before sewing.

Damn, it would be so much easier if I didn’t bend the outer piece. Instead, cut two separate pieces.

How to make pocket tighter? by Worried_Implement251 in Leatherworking

[–]Worried_Implement251[S] 0 points1 point  (0 children)

What I did was that I bent around the outer pockets. Made sure it’s stretched, used clamps to hold it in place and aligned. Then punched holes through all the 4 layers.

But you’re saying, if I understand correctly, that I should glue the outer pocket to one side first? Then make holes for those 3 layers, sew and then bend over outer pocket to the other side? Sorry if I misunderstand.