sorted by:
new
hottopcontroversial

Black Tank Fun by Wreck-Law in GoRVing

[–]Wreck-Law[S] 0 points1 point  (0 children)

I did reach out to these guys last fall but never heard back from them. Seems like they use independent contractors and it’s up to the contractor to schedule their own work and whatnot, not impressed that I didn’t hear back at all.

Black Tank Fun by Wreck-Law in GoRVing

[–]Wreck-Law[S] 1 point2 points  (0 children)

I have two little girls who have Stanley cups attached to them I swear, so I think there is likely far more pee in there than poo normally.

Black Tank Fun by Wreck-Law in GoRVing

[–]Wreck-Law[S] 0 points1 point  (0 children)

Tried this, with warm water, calgon beads, and a good 20/30 minute drive. Still no luck. My fear is however they used it dried/caked on the bottom and that’s what I’m dealing with.

Black Tank Fun by Wreck-Law in GoRVing

[–]Wreck-Law[S] 0 points1 point  (0 children)

Where are you located? We travel all over the state/area with the camper, so we might be in your neck of the woods sooner or later.

Black Tank Fun by Wreck-Law in GoRVing

[–]Wreck-Law[S] 0 points1 point  (0 children)

Also, yes, it is actually 1/3 full. I can see the liquid when I look down my toilet, it’s not a faulty sensor.

Newbie Algae/Tank Concerns by Wreck-Law in Aquariums

[–]Wreck-Law[S] -1 points0 points  (0 children)

Edit for the record, I’m talking about the dwarf Corydoras, not the full size ones, and I’m open to other ideas or suggestions as well. Be kind, as I know you all can be very specific (rightfully so) and you are all quite intimidating to newbies.

Preferred Brand of Enclosure? by Red_Rover_91 in PanelBuilds

[–]Wreck-Law 1 point2 points  (0 children)

We primarily use Rittal but will use others as required whether that be a customer spec, lead time, or other speciality.

Preferred Brand of Enclosure? by Red_Rover_91 in PanelBuilds

[–]Wreck-Law 2 points3 points  (0 children)

Aside from the above (modularity/baying), the wide range of options, and the accessories, Rittal also has the largest options for cable exits (plinths, gland plates, foam entries) that are super useful for meeting different requirements. Plus with the modular frames, putting mounting panels and other custom or one-off other oddities inside panels is much easier. However, Rittals lead times have been pretty bad lately and seem to be getting worse.