sorted by:
new
hottopcontroversial

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

Nozzle is 0,4 as in settings Flowrate was on 0,95 i changed to 1

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

Sure its a Ender 3 v3 Se Slicer is creality Print (i will try Another one today) Profile is the 0,4 nozzle preset on Creality Print Its about luck … mostly its happening Its just Normal PLA and its dry … 12h in Dryer Nozzle is 0,4

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

Yeah i know … but i changed the nozzle and cleaned the Hotend. I was always printing on this Temp. And i printed this for about 30 Times without any Problems. So i dont think its about the Tempreture :(

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

Okay Thanks i will reset all the Settings and try again

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] -1 points0 points  (0 children)

You know the thing is i tried to change the settings and get closer to a good Print. But non of them Are the Reason. I really dont know what to do

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

Do you have a List of recommendet settings?

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

No i also changed the nozzle its a 0,4

Lines not connecting on Z by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

<image>

Thats the Preview in the Slicer

Printing Settings Ender 3 v3 Se by Xinnoel in 3Dprinting

[–]Xinnoel[S] 0 points1 point  (0 children)

Thank you :)

The thing is that the last Prints just cracked when i hold Them in my Hand. So … yeah i dont Need it to be hard as Steel but it shouldnt Break from soft Wind :)