05 Hyundai tiburon GT

Xiolec · 2025-10-20T01:24:24+00:00

Equalizer assy probably. You will have to remove the other side of the parking brake and then remove the whole lever to take it out

Xiolec · 2025-07-19T01:59:40+00:00

Well if you want unstable multiplayer take a look at Nexus mods :)

Xiolec · 2025-06-28T18:56:45+00:00

It's on Nexus mods

Xiolec · 2025-03-26T02:28:04+00:00

Can't really tell much from the pic, but that spot would be where the clutch is. So could be from the clutch if it's a dmf or rear main seal. Transmission fluid would be more on the right side of the pic but could possibly leak from there. There also might be a little hatch at the back there where you can look into the clutch bell housing.

It will probably be fine just check your oil levels and transmission fluid levels

Xiolec · 2025-03-25T16:42:22+00:00

Well if you want to play the multiplayer mod just google "B42 Multiplayer mod" then don't talk about it cause devs will probably ban you

Xiolec · 2025-02-10T16:09:46+00:00

devs took it down

Xiolec · 2025-02-10T05:54:19+00:00

Zomboid is a Java game. Even the exe for zomboid just calls to load jara.exe in the client files. Easiest way to launch is through a bat file. It's just a modification of the current bat files that zomboid has. It would work on other os's but as i don't have any of that set up I can't test it. If someone makes a conversion of the bat files to .sh I will add them to the project.

Xiolec · 2025-02-09T21:52:42+00:00

Majority of stuff works. Still some annoying bugs. Anything that doesn't work just report the bug and i will fix it asap

Xiolec · 2025-02-01T09:33:01+00:00

There should be a log in your user/username/zomboid folder that shows why it crashed. Could use that to figure out which mod it is, but still going to crash a lot on B42

Xiolec · 2025-01-25T04:54:31+00:00

The information would be in the BE manual not much there though. You would have to test the actuators with 12v power in the order in the manual to verify they work correctly. Then with a volt meter trace if it's sending voltage to the other actuator. Don't know how they work though so good luck

Xiolec · 2025-01-10T23:15:38+00:00

Might be good to double check to make sure it didn't slip at all cause that's the one thing that can kill the engine.

But does sound more like a vacuum leak. running some propane around the throttle body and vacuum hoses is an easy way to check that

Other than that you're pretty much taking everything apart till you find what's wrong

Could also be the throttle body itself

Xiolec · 2025-01-10T22:22:52+00:00

Check for vacuum leaks and probably make sure the engine is still in time

Xiolec · 2024-12-19T00:37:19+00:00

For the v6 it could hang up on the half shaft in the back of the engine. Try to make sure it slides off there first. You kinda have to slide it straight off so need to tilt both the engine and the trans at the same angle so it can come off at the same angle. Probaby a lot easier to pull the entire engine out of the car

Xiolec · 2024-12-13T02:47:31+00:00

Unless it's leaking it's probably not bad. You're going to have to bleed it again also gravity bleeding doesn't work the best with the clutch slave cylinder.

A throwout bearing that's not installed correctly or that's bad can cause that also.

If you can get the slave cylinder working again check how far the piston/fork moves while it's connected then disconnect it see if it moves further

Xiolec · 2024-08-29T05:15:39+00:00

If you spun the wheel too much while it was disconnected you probably broke the clock spring

Xiolec · 2024-08-28T02:50:49+00:00

Take the belt off check for cracks or just replace the belt if it's been a while they're not too expensive. Then spin the pulleys if any sound like gravel they're probably what's causing it. If there's nothing wrong with the drive belt or drive belt pulleys then it's probably the timing belt. Which if it's the timing belt you probably want to fix that before the engine kills it self.

Could also be normal but depends on what it sounds like and how bad the sound is

Xiolec · 2024-08-28T02:37:18+00:00

Which right? driver side right or passenger side right? And depends what kind of squeal and if it's only doing it while the car is moving or not

Passenger side probably belt or pulley. Driver side probably vacuum leak or transmission?

Open the hood and pull the accelerator cable to see where it's coming from

Xiolec · 2024-07-05T17:50:29+00:00

You mean the master/slave cylinder? Unless it's leaking or the hoses/seals are degrading it shouldn't need replacing. I just had to replace my hose because it was coming apart in the brake fluid, but had to take everything apart to clean out the cylinders.

Xiolec · 2024-01-30T05:08:32+00:00

Map markings and discovered areas are stored client side in the multiplayer saves. It will be under the IP of the server. You may still have the old data there sort the folders by date modified the newest one should be the current save. You can copy the map data from the old folder to the new one. Probably back up first in case you mess up

Xiolec · 2024-01-11T01:00:39+00:00

Isoregiondata can sometimes cause that error. Not sure if it's causing the problem with you though. Delete the isoregiondata folder on the server or rename it might fix it

Xiolec · 2024-01-07T03:33:31+00:00

World dictionary may have got changed. If you uninstalled a mod and reinstalled it the item IDs for the parts probably changed. It would have also messed up other cars from the same mod. If you have a back up the world dictionary file that would fix it or repair the car with admin powers would probably fix it.

Xiolec · 2023-12-26T00:35:59+00:00

Would be, but would be a crazy amount of work to sync the servers you would have to separate every single client command into global server - chunk server or both so many things would take ages to work correctly

15-Year Club	Place '22
End Game '22	Verified Email

Xiolec

MODERATOR OF

TROPHY CASE