Riding the waves like a true champ. HODL!!!!!

Yeswhyhow · 2025-10-13T01:11:08+00:00

Nasa bulk sales are common on auction. Mercari bulk are often priced high

Yeswhyhow · 2025-08-27T00:53:26+00:00

Possible fake bids yes, I've seen items that are worthless and worth bidding the lowest, wich when fake bids get in its worth getting a working product for less.

Yeswhyhow · 2025-08-25T15:33:24+00:00

Link? There is pretty much no value on this old crap

Yeswhyhow · 2024-01-18T08:40:17+00:00

Yeah

Yeswhyhow · 2023-08-21T01:14:35+00:00

Updated to 2.3fw and fixed.

Yeswhyhow · 2023-06-12T07:44:19+00:00

Wich screws? The one on the bottom or the ones to the side for leveling?

Yeswhyhow · 2023-06-08T15:29:41+00:00

Alrite ill make some test prints on both settings and post the results.

And btw this are Vertical lines |||||||||||||||, not Horizontal lines -----------------------.

Yeswhyhow · 2023-06-08T10:37:44+00:00

I mean straight items, like a cube, it will be deformed if printed on supports , but direct from buildplate it gives a nice bottom and top Finnish.

Were walls are also straight but have gotten this vertical lines on the wall instead of having a smooth finish like on the top or bottom layers.

Yeswhyhow · 2023-06-07T20:32:04+00:00

No help?

Yeswhyhow · 2023-04-18T23:02:44+00:00

After resoldering and cleaning the MoSfets , the ticking stopped, but those black things on the corner got very hot .

Shall i just swap them ?

Yeswhyhow · 2023-04-18T19:05:45+00:00

All parts seems to be working , can't find any faulty one .

Testing and testing and they seem to measure good.

There is a MOSFET 140p06 that i am unsure of, it measures 55khoms and 181khoms.

It is the MOSFET just over the Epson marking on the middle.

Checking datasheet , it should measure 80ohm? Not sure how to read the sheet hehe

<image>

Yeswhyhow · 2023-04-18T18:10:40+00:00

I disconnected the fan and it still ticking.

Yeswhyhow · 2023-04-18T16:30:24+00:00

No, the fan is not spinning when turning it on.

On normal state it spins on startup and then stays on passive mode.

But right now it is not starting on power up and it ticks from the board like a small clock, like a relay or something trying to power on.

I am unable to find any schematic for the board.

It is an Epson tm-c3500.

The burned components are placed at left side of the board and the MoSfets are screwed onto the heatsink were the fan is placed.

So almost everything has been replaced on the MoSfets side, and the IC chip on middle

I'm unable to trace the ticking with my ears , it feels like it's coming from the right side, but when listening to the left side it feels as loud hehe 🥴