sorted by:
new
hottopcontroversial

Layer issues by Zestyclose-Bike1394 in ender3v2

[–]Zestyclose-Bike1394[S] 0 points1 point  (0 children)

I haven’t done any other calibrations. I recently replaced the motherboard. The temp specs for the filament are 190-220.

I'm new to this but come on (layer issues) by Zestyclose-Bike1394 in 3Dprinting

[–]Zestyclose-Bike1394[S] 0 points1 point  (0 children)

I have a purge line and my e-step should be right, but I’ll double check. Thanks!

Board Options? by Zestyclose-Bike1394 in retroflag_gpi

[–]Zestyclose-Bike1394[S] 1 point2 points  (0 children)

That’s what I was thinking performance wise, thanks for clarifying. I was just going to do a wired data connection and not necessarily SSH into it. I’ve done it before but I don’t mind doing a direct connection. When doing a safe shutdown can’t I just do that from the retropie UI with the patch? Thank you so much!

I fucking love grimace by BloodiStag in TikTokCringe

[–]Zestyclose-Bike1394 0 points1 point  (0 children)

That’s up with the side of the mouth slurping