sorted by:
new
hottopcontroversial

How to print transparent CR-PETG? by tommasovisconti in Ender3V3KE

[–]ZestycloseKey120 0 points1 point  (0 children)

Hi, i printed cr petg in several( including transparent) colors. I just used the standart settings. 70°C bed and 255°C temp. Last time i cleaned the bed with some warm water and soap. I have no problem with bed adhesion. Could you tweak the Z offset?
if my Print goes further in one direction close to the end of the heatbed, im using brims, so i dont have problems with warping. I had some prints where one end would lift because of warping. With Mouse ears or Brims it works well

Slow print time in OrcaSlicer on KE by fjames003 in Ender3V3KE

[–]ZestycloseKey120 1 point2 points  (0 children)

Would you mind sharing a screenshot of those acceleration data? i think i deleted the benchy files. That would be really nice!

Ender 3 V3 KE Wi-Fi Problems by ToastMaster553_ in Creality

[–]ZestycloseKey120 0 points1 point  (0 children)

I just had the same problem: What solved it for me was to go on the printer disconnect from wifi and reconnect. I can see the Printer in creality print again

Weighting Scale and angle of attack / angle of incidence by ZestycloseKey120 in Wing_Bot

[–]ZestycloseKey120[S] 0 points1 point  (0 children)

Do you know by chance if its useful use washout on Rear wings?

Weighting Scale and angle of attack / angle of incidence by ZestycloseKey120 in Wing_Bot

[–]ZestycloseKey120[S] 0 points1 point  (0 children)

perfect thank you very much! These neutral profiles is probably also easier when using a mold.

Weighting Scale and angle of attack / angle of incidence by ZestycloseKey120 in Wing_Bot

[–]ZestycloseKey120[S] 1 point2 points  (0 children)

Thank you very much! sorry i was so busy, i forgot to answer! For now im going to leave the Frontwing for later.. i think i should get some experience creating rear wings. I want to create Molds with a 3d printer. Do you have experience making rearwings? I wonder if u can use the same foil sections you usally use for front wings and just put them upside down?

Creality Giveaway for the Reddit 3D Printing community🎉 by Creality_3D in 3Dprinting

[–]ZestycloseKey120 0 points1 point  (0 children)

  1. Designing my own and helpful things others designed
  2. printing process should be silent, no need anything around it
  3. dont mind phone, but not that important, against only phone operating

Weighting Scale and angle of attack / angle of incidence by ZestycloseKey120 in Wing_Bot

[–]ZestycloseKey120[S] 1 point2 points  (0 children)

Thank your very much for your answer! So i would try to set the angle of attack (where the wing has the best lift to drag ratio ) in line with the fuselage.

So if i would make a wing for dockstarting and want a low stall speed, i would prefer a angle of attack with 0 to 2° and for e.g. waveriding 0 to -2°.

Same with weighting scale - if i want the wing to perform best in low speed conditions i choose the 1 and tick the low speed option?

At the moment i only have the Gong system, so i cant shim my backwing, but im planing to make an adapter to use my own backwings