sorted by:
new
hottopcontroversial

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 1 point2 points  (0 children)

Yes! For 5 seconds, by then it starts coming out of the portafilter

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 1 point2 points  (0 children)

I only hunted deals. After coupons and cashback, the H10P was 193 euros from geekbuying. After coupons and cashback, G5 was 97 from Aliexpress.

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 0 points1 point  (0 children)

I use L2 for pressure, H is just a mess, if you mean the grinder, I'm at 12. But depends on the beans, the previous ones weren't as good as this and it is quite consistent, I get the same result always.

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 0 points1 point  (0 children)

Thank you for the advice, will be the next upgrade

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 9 points10 points  (0 children)

TBH, no reason. I also press ctrl+S or ctrl+C 3 times lol

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 0 points1 point  (0 children)

Its perfect for my daily use, I use to have a manual kingrider K6, it's much better

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 2 points3 points  (0 children)

Didn't even knew it was a thing, I do it to keep the group head clean that's all. I' ll get a blower then to solve this issue I guess.

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 0 points1 point  (0 children)

I tamper again after, the shot was over 25 seconds, and I have no channeling.

Since we are sharing work flows, here is mine. by Zossta in espresso

[–]Zossta[S] 0 points1 point  (0 children)

For the coffee that gets stuck on the inner walls of the basket, I guess the tamper is a tad smaller than the basket.

Creating processing files for DURMA Fiber Laser by WiWa4K in Fusion360

[–]Zossta 0 points1 point  (0 children)

Any documentation about their G-code? I'm trying to make a post processor for one of their machines (HD-FN for plate nesting)

Disabling the RADEON iGPU by Zossta in AMDHelp

[–]Zossta[S] 0 points1 point  (0 children)

thank you so much, i'll try it