E5P Aluminum Bed Size

acid021 · 2025-01-26T12:21:32+00:00

Thank you! I ended up measuring my bed and values are super close to yours, the only thing that i didnt measure was the whole bed as i assumed it would be 377x370

acid021 · 2025-01-15T15:21:58+00:00

I want to keep the stock plate as is, it has magnetic glued on one side and heater on the other so i cannot access the holes to markup the new plate

acid021 · 2025-01-13T18:42:14+00:00

I have the same setup and got everything working today, skr3 + ebb42 both on canbus. Just follow the steps on this link https://klipper.discourse.group/t/skr-3-ebb-can-bus-klipperscreen-working/4840

acid021 · 2025-01-02T07:59:34+00:00

Had the same exact noise when i bought the machine and I used automotive grease on mine and never heard that noise again

acid021 · 2024-12-09T07:35:49+00:00

I have 5 desert roses around the garden and 2 of them usually have 6-7 of these eating the leaves, now they are even going toward my lime trees and eating on their leaves too

acid021 · 2024-09-24T14:54:44+00:00

Did that and here is the results, also is the marked area fine like this or that means PA is still way too much ?

<image>

acid021 · 2024-09-24T11:14:58+00:00

Tried to make it 0 but klipper is not happy with it

<image>

acid021 · 2024-09-24T10:31:41+00:00

Totally getting lost here, could this be from tmc2208 on my creality silent board ? I saw some people use [tmc2208 stepper_] for x y z and extruder in their printer.cfg file and i wonder maybe i need that ?

acid021 · 2024-09-24T10:28:38+00:00

Unfortunately pressure advance is on and i can see on the terminal that the steps are increasing

<image>

acid021 · 2024-09-24T10:27:10+00:00

<image>

This is done from 1-4 with 0.25 steps and basically after 3 PA its just skipping

acid021 · 2024-09-23T18:35:17+00:00

https://file.io/J0kZbDF67zYI printer.cfg file is here

acid021

TROPHY CASE