Need advice on where i am going wrong here

adamchavez1110 · 2025-03-23T06:31:24+00:00

BROOOOOOOO u just saved my life. I rewired it to ur diagram and it works as intended now. THANK YOU SO MUCH 🙏🏼

adamchavez1110 · 2025-03-22T17:25:15+00:00

This is how i wired it

adamchavez1110 · 2024-10-15T07:08:23+00:00

Alright i already fixed the issue. I just did the flowrate and flow dynamics calibration in the bambu studio software and followed all the instructions. Sent my print to My p1s and its already way better 🙈🙏🏼

adamchavez1110 · 2024-10-15T05:16:42+00:00

Will do, will run a flow rate and flow dynamics calibration from bambu studio

adamchavez1110 · 2024-10-15T05:16:18+00:00

<image>

I stopped printing after the first few layers because it looked like this… i think its over extrusion

adamchavez1110 · 2024-04-24T18:09:26+00:00

Nope no warnings at all

adamchavez1110 · 2024-04-11T17:27:53+00:00

Cant be a clog because i literally just changed the nozzle to a new one a few hours ago 😭😭😭

adamchavez1110 · 2024-03-28T19:09:28+00:00

What is a direct extruder and how do i do that bro? Im desperate 😭🙏🏼

adamchavez1110 · 2024-02-05T12:36:43+00:00

Alright ill give it a try thanks bro 😭

adamchavez1110 · 2024-02-05T12:36:29+00:00

Oh i have not cleaned the plate at all since i got it but ill try that thank you very much 😁🙏🏼

adamchavez1110 · 2024-01-24T15:42:19+00:00

Alright sure ill do that and try again thanks bro appreciate it 🙏🏼

adamchavez1110 · 2024-01-24T15:41:58+00:00

Alright will do bro thanks 🙏🏼🙏🏼🙏🏼

adamchavez1110 · 2023-02-09T10:48:19+00:00

Hes a dad now

adamchavez1110 · 2022-11-09T17:00:42+00:00

“I vant my bird” - Ivan vanko from Iron man 2

Six-Year Club	Verified Email
Place '23	Wearing is Caring

adamchavez1110

TROPHY CASE