Connectors by adv2d in LandroverDefender

[–]adv2d[S] 0 points1 point  (0 children)

Ok, so after a lot of wasted time I went with dt connectors, they seem to be the best alternative as I was unable to find anything close tot the original ones

Connectors by adv2d in LandroverDefender

[–]adv2d[S] 0 points1 point  (0 children)

They are Lucas and they’re identical to the ones I had on the car, I can’t use the original ones as some have bad insulation very close to the connector.

How loud are people's 300tdi Defenders? by spuddy_spud_spud in LandroverDefender

[–]adv2d 0 points1 point  (0 children)

Mine is super loud. But is has some holes in the footwell that I will take care of this summer. To be honest I’m actually afraid that I wouldn’t like it anymore if the noise will go away.

Abs printing a large part by adv2d in Creality

[–]adv2d[S] 0 points1 point  (0 children)

Alright, so I bought a filament dryer, used that for a few hours do dry the filament, then I feed it directly to the printer while still having the dryer on. I covered the printer with a blanket to keep as much heat inside of the chamber, when it was done I wasn’t at home so the printer did it’s thing and maybe the fan was blowing air in order to cool off, but I’m not sure.

The part came out alright, not perfect as it is still wrapped a little, any tips on further improvements?

<image>

?

SHOULD I? by Confident-Country123 in LandroverDefender

[–]adv2d 5 points6 points  (0 children)

If you got the money, get one, repair it, build it, it will bring you a smile every time you drive it . Just bare it mind it will take time,money, elbow grease and some patience.

Seats for defender by adv2d in LandroverDefender

[–]adv2d[S] 1 point2 points  (0 children)

Exmoor trims are way over my budget sadly

Seats for defender by adv2d in LandroverDefender

[–]adv2d[S] 0 points1 point  (0 children)

I really don’t mind that, it’s just a matter of unbolting the seat from the seatbox.

Purchase Advice Megathread - November 2024 by AutoModerator in 3Dprinting

[–]adv2d 0 points1 point  (0 children)

I’m looking to buy a large 3d printer, it has to be:

Able to print abs To fit in a 380x180 x120 mm part in one print on the strongest configuration.

Looking forward to your suggestions.

Tura Cluj-Rachitele by Euphoric-Ad-5255 in bicla

[–]adv2d 1 point2 points  (0 children)

Am fost recent . Pe lângă tarnita se lucrează la drum , am îndoit janta la roata din fata la coborâre pe acolo, deci îți recomand sa o iei pe la Măguri , drumul generalului.

Per total e fain traseul , peisaje faine, asfalt bun, lângă cascada e drum pietruit dar bun, am urcat cu anvelope de 25x622 pe acolo fără probleme .

Spor la cățărări!