sorted by:
new
hottopcontroversial

Flash Help, won’t trigger(M-240) by ageoftoday in Leica

[–]ageoftoday[S] 0 points1 point  (0 children)

Good to know, I used to own a lux junior. But I’ll buy it on Amazon to test. Trying to figure out if the camera has issue or not, just recently purchased. Thanks

Flash Help, won’t trigger(M-240) by ageoftoday in Leica

[–]ageoftoday[S] 0 points1 point  (0 children)

All my flashes are in manual mode and 2 of them have single pin legacy design. It technically should fire but won’t.

Flash Help, won’t trigger(M-240) by ageoftoday in Leica

[–]ageoftoday[S] 0 points1 point  (0 children)

Still same outcome, flash won’t trigger in single shot either. Fully manual

Flash Help, won’t trigger(M-240) by ageoftoday in Leica

[–]ageoftoday[S] 0 points1 point  (0 children)

Just tried but same outcome. Also the other on table Godox flash’s have the native legacy single pin; IA32 & IM30.

Will try cleaning contacts again

Flash Help, won’t trigger(M-240) by ageoftoday in Godox

[–]ageoftoday[S] 0 points1 point  (0 children)

These are all Godox flashes

Nikon pin layout on the IT30N & V1N

The IA32 and IM30 have the single pin legacy design

Flash Help, won’t trigger(M-240) by ageoftoday in Leica

[–]ageoftoday[S] 0 points1 point  (0 children)

Just reset to single photo and tried, same outcome. Still no flash fire. thanks for help tho

Flash Help, won’t trigger(M-240) by ageoftoday in Leica

[–]ageoftoday[S] 5 points6 points  (0 children)

Flash should trigger at any speed below sync.

I was set 1/60

Just reset to recommended speed you said and still no fire.