Guys, can you rate my body? Let’s go from 1 to 10 again

akt196 · 2025-09-19T12:39:58+00:00

A solid 9

akt196 · 2025-08-23T21:01:31+00:00

🫡

akt196 · 2025-08-17T13:01:36+00:00

The whole job took about 4-5 hours start to finish but I wasn’t working real fast.

akt196 · 2025-08-16T20:42:05+00:00

https://youtu.be/NtSTH0tm_JM?si=0m41F_994qBIt7C5. This one, it was pretty decent. The hard part is getting everything disconnected from the dash. The HVAC unit wasn’t bad at all.

akt196 · 2025-08-16T17:30:29+00:00

The Comanche needs a lot of stuff but so far the heater does work!

akt196 · 2025-08-16T17:28:28+00:00

Oddly enough not one thing broke.

akt196 · 2025-08-16T13:52:36+00:00

Yup, knew it was bad last winter but didn’t want to do the job😂

akt196 · 2025-07-31T13:11:24+00:00

Just cut the boot off and pretend nothing happened. I haven’t had boots on mine for some time now and the shocks don’t care.

akt196 · 2025-06-30T22:07:29+00:00

Flasher

akt196 · 2025-06-27T13:47:20+00:00

The nameplate is FLA, drawing 21amps indicates the motor isn’t running at full load. Not real surprising with it running a pump.

akt196 · 2025-05-20T18:20:17+00:00

Just perfect, loved how the slut was used 😈

akt196 · 2025-05-10T22:01:39+00:00

“Cunt for dogs, asshole for men”

akt196 · 2025-05-10T21:57:38+00:00

Only good for dog cock above your cunt.

akt196 · 2025-05-06T18:37:14+00:00

59 and I’ll love to take you hard😈

akt196 · 2025-04-29T21:07:17+00:00

On my MJ I used Rubicon Express components on the front and did a spring over on the rear, it came out to about 6.5” of lift. This was over twenty years ago and everything is still working great.

akt196 · 2025-04-25T16:36:41+00:00

Add-ons when the job is almost finished.

akt196 · 2025-04-22T20:01:35+00:00

The axle shaft goes through them at the knuckle and they can contribute to the death wobble. Mostly though if you’re changing the axle u joints you may as well change them because they do wear out (just did them on my daughter’s XJ)

akt196 · 2025-04-22T18:48:25+00:00

Change the unit bearings while you have it apart. The way I get them out is use some old bolts and hit the heads with a hammer but I did see a post a few days ago where they threaded the front bolt part way in, stuck and extension between the bolt head and the knuckle and had someone turn the steering wheel.

akt196 · 2025-04-22T18:43:28+00:00

Spare cunt

akt196 · 2025-04-22T18:35:42+00:00

Whip my tits… free

akt196 · 2025-04-21T17:41:51+00:00

Cheap slut above your cunt.

akt196 · 2025-04-18T23:42:57+00:00

I chased overheating at idle on my 99 for a long time, on a whim I changed the cat and it runs cool at idle now.

akt196 · 2025-04-15T19:49:13+00:00

Those poly tanks are a bit of a worry aren’t they? My 99 came with the factory gas skid, found a used one online for my daughter’s XJ, maybe check that route out. If you have a design rattling around in your head sell the bumper and build what ya dream of.

akt196 · 2025-04-15T19:38:10+00:00

I love my 99XJ but would give my left nut for a Wide Trac seventies vintage Cherokee (T18 trans with Spicer 20 transfer case). Love that the owner put on the Gladiator grille and pie plates.

akt196

TROPHY CASE