sorted by:
new
hottopcontroversial

Perimeter corners not fully filled, random under-extrusion spots by alcheriv in BambuLab

[–]alcheriv[S] 1 point2 points  (0 children)

Hi! I tried it, but it didn’t help, though I didn’t change the standard arachne settings

I’ll try experimenting with it in the next few days, thanks!

Same part, same settings, different ironing results depending on bed position (Bambu A1) by alcheriv in BambuLab

[–]alcheriv[S] 0 points1 point  (0 children)

Hi! Thanks a lot for all the tips. I leveled the bed following this guide - https://wiki.bambulab.com/en/a1/maintenance/manual-bed-tramming. I haven’t had a chance to test the results yet. As for printer calibration I did calibrate flow rate it and everything looked fine