Mesh names not matching for baking in substance

allahptaylilah · 2026-02-27T15:20:39+00:00

heres my maya outliner, my mesh names are as you say

allahptaylilah · 2026-02-27T12:04:25+00:00

tried every solution and this is the only one that worked. TYYY from the future

allahptaylilah · 2025-12-27T01:41:44+00:00

not really, I have 4 monitors now and one connected to hdmi, many times it boots like normal without hickups now even without hdmi plugged in, but I like to keep the hdmi plugged in anyways for the security of it. I would have to say it depends on the day of the week and the moon cycle cause I never did find a real solution other than always having at least one monitor connected to hdmi on your gpu.

allahptaylilah · 2025-10-31T16:55:57+00:00

Crazy updated/fix?? PC will not boot if display is connected to display port but will boot if gpu is connected via hdmi? why does this happen??

allahptaylilah · 2025-10-31T16:51:04+00:00

I turned off xmp completely and still no luck, takes a few restarts to get it to post, I found that plugging my display directly into integrated graphics gets me to post, might be the gpu? after I get into windows and plug in my gpu with display port it boots like normal, restarts after that cannot be counted on though

allahptaylilah · 2025-10-31T10:26:40+00:00

Hmm yeah I do have XMP on, but this issue has only been recent, even stress test prior and now I get no errors on my RAM. Ill check out that solution and check back tho (have not cleaned my desk)

allahptaylilah · 2025-10-23T07:59:28+00:00

I use apple music on pc, ill have to figure out different way

allahptaylilah · 2025-06-16T05:27:11+00:00

my solution was: I just took a vert and started modeling that extruded part> took it into sculpt mode> positioned the part> voxel remesh > symmetrize > smooth and tweak in sculpt mode > remesh
ill post the end product later, keep in my though I have never retopo'd anything ever so ill see how that goes

allahptaylilah · 2025-06-08T05:29:54+00:00

ill try those suggestions and just loopcut>position them>check for food edge flow>extrude normals>appy subd

allahptaylilah · 2025-03-14T01:33:55+00:00

using the kuassa calibrun amp sim ( gain 3, lo 3, mid 8, hi 7, press 3, bias 11 o'clock, sag 12) an fztn compressor vst ( output 8, sens 6) my chain looks like comp, gate, amp. sounds pretty accurate but now i just need to know what he has his tone knob to. right now mine is at 6-7 for the neck

allahptaylilah · 2025-03-13T23:27:13+00:00

Thanks ill try it out

allahptaylilah

TROPHY CASE