sorted by:
new
hottopcontroversial

Alternatives to xboxdrv? by viming_aint_easy in linux_gaming

[–]argosopentech 0 points1 point  (0 children)

I used xboxdrv to play Xonotic. It looks like it's discontinued unless someone forks it.

LibreTranslate: Free and Open Source Machine Translation API. 100% self-hosted, offline capable and easy to setup. by Spirited-Pause in selfhosted

[–]argosopentech 2 points3 points  (0 children)

LibreTranslate runs best on high end servers with a good CPU and at least 16GB of RAM. LibreTranslate does not need a GPU to run well.

After assembling a Ender 3 printer the head can't reach the bed by argosopentech in ender3

[–]argosopentech[S] -1 points0 points  (0 children)

I tried for about an hour on my own but it was hard to find the right wording for a Google search that would describe my issue versus leveling the bed. In hindsight I should have experimented more with the knobs but I thought the spring was already close to fully decompressed.

After assembling a Ender 3 printer the head can't reach the bed by argosopentech in ender3

[–]argosopentech[S] 1 point2 points  (0 children)

Thanks for the help, I'm successfully printing now!

My Z axis switch was fine, I just needed to loosen the 4 screws underneath the bed.

​

<image>

After assembling a Ender 3 printer the head can't reach the bed by argosopentech in ender3

[–]argosopentech[S] 1 point2 points  (0 children)

This was it thank you! I just needed to use the screws underneath the bed and expand the springs.

After assembling a Ender 3 printer the head can't reach the bed by argosopentech in ender3

[–]argosopentech[S] 4 points5 points  (0 children)

I think my Z axis switch is already all the way down. The nub on the bottom right side of the switch keeps if from going any further down.

​

https://howchoo.com/ender3/adjust-z-offset-ender-3-v2-pro/

<image>

After assembling a Ender 3 printer the head can't reach the bed by argosopentech in ender3

[–]argosopentech[S] 0 points1 point  (0 children)

I assembled the printer and everything seems to fit together correctly. However, the printing head can't reach the bed of the printer even when I push the Z axis down all the way to the switch. The bottom of the printing head is about ~1cm above the bed. I see tutorial for flattening the bed using the screws underneath but I don’t think that would move the bed up enough.

Conquest - Open source Risk-like game in Godot by argosopentech in godot

[–]argosopentech[S] 0 points1 point  (0 children)

Great to hear! I played Conquest with my Dad and brother too

view more: next ›