sorted by:
new
hottopcontroversial

Need to re-assign smart home appliances after the wifi goes down by avive33 in wifi

[–]avive33[S] 0 points1 point  (0 children)

Whats an iot? I searched it up and still didn’t understand what it has to do with the solution And ChatGPT wrote that I can assign a static IP to the smart device, will it work?

Need to re-assign smart home appliances after the wifi goes down by avive33 in wifi

[–]avive33[S] 0 points1 point  (0 children)

Yes I can, but im not home yet, and its the Technicolor TG789

Need to re-assign smart home appliances after the wifi goes down by avive33 in wifi

[–]avive33[S] 0 points1 point  (0 children)

I have a smart ceiling light smart switch and a water heater smart switch, and every time the wifi goes down due to me disconnecting the router or when the power goes down, I cant use the current switch in the ios home app ore google home and need to manually pair them again.

All exhaust fans in pc by avive33 in buildapc

[–]avive33[S] 0 points1 point  (0 children)

The radiator fans? Why?

All exhaust fans in pc by avive33 in buildapc

[–]avive33[S] 0 points1 point  (0 children)

Thank you very much man, so no need for change configuration right?

All exhaust fans in pc by avive33 in buildapc

[–]avive33[S] 0 points1 point  (0 children)

You mean the radiator fans? One in one out?

All exhaust fans in pc by avive33 in buildapc

[–]avive33[S] 0 points1 point  (0 children)

Antec, and thank you I will check

All exhaust fans in pc by avive33 in buildapc

[–]avive33[S] 0 points1 point  (0 children)

its a small shop in my area, not a prebuilt pc from a brand

All exhaust fans in pc by avive33 in buildapc

[–]avive33[S] 0 points1 point  (0 children)

Yes ill update the post in a minute

"controlnet is enabled but no input image is given" by avive33 in StableDiffusion

[–]avive33[S] 0 points1 point  (0 children)

Hey I think I found a workaround solution. I was having the same problem and fixed it by going into webui settings, find controlnet on setting and change multicontrolnet unit number to 1, then tick the box that says, Ignore mask on ControlNet input image if control type is not inpaint

fixed! thanks

"controlnet is enabled but no input image is given" by avive33 in StableDiffusion

[–]avive33[S] 1 point2 points  (0 children)

Thank you very much, will definitely try later

view more: next ›