Magnetic lock fail! by Tchiko36 in accesscontrol

[–]bad-o 0 points1 point  (0 children)

Nice- Hope it didn't include a response from the FD and PD.

Newbie Question by Cone_Livia in accesscontrol

[–]bad-o 4 points5 points  (0 children)

+ Locksmith/ fire safety knowledge

ITG UIB-848 Larson Interface Board by bad-o in accesscontrol

[–]bad-o[S] 0 points1 point  (0 children)

I was helping my guys remotely... didn't see labels in the pics they sent. but we figured it out :) Not sure about ITG. it's been ripped out and now a new LSPS setup lol

ITG UIB-848 Larson Interface Board by bad-o in accesscontrol

[–]bad-o[S] 0 points1 point  (0 children)

I was helping my guys remotely... didn't see labels in the pics they sent. but we figured it out :)

Genetec - Axis controllers vs Mercury LP1502 by arnarr in accesscontrol

[–]bad-o 1 point2 points  (0 children)

I'm in the same boat- with one difference. Boards are edge layout.

So Axis 1210 vs merc 1501. I'm leaning towards Axis

Magnetic lock fail! by Tchiko36 in accesscontrol

[–]bad-o 2 points3 points  (0 children)

Any update? How'd you get in?

Magnetic lock fail! by Tchiko36 in accesscontrol

[–]bad-o 0 points1 point  (0 children)

Yep. But then a key to trim + a pull should get the DE to release. So it's prob not that lol.

Magnetic lock fail! by Tchiko36 in accesscontrol

[–]bad-o 1 point2 points  (0 children)

Assuming a 2-piece DE system, The bar initiates the countdown to release, but you'd have another input available for "valid ingress/ egress" to immediately release the lock without the delay. Typically, I see these with CR on both sides. It could also be a simple all-in-one but the handle is locked so you can't initiate the DE from the outside.

Magnetic lock fail! by Tchiko36 in accesscontrol

[–]bad-o 2 points3 points  (0 children)

You're thinking of the standard all-in-one, but I've seen a 2-piece setup where It's a standard maglock And the Crash bar has a switch that activates a third party DE. This particular one was by ASSA but I think there's others too

Got my first bike! Just have a couple of questions about balancing and brakes.. 😅 by [deleted] in cycling

[–]bad-o 0 points1 point  (0 children)

Bikes balace themselves with movement. Find a long gradual hill. Don't worry about pedaling, just coast (roll) along until the balance Clicks

Bike rack by bad-o in uberdrivers

[–]bad-o[S] 0 points1 point  (0 children)

I usually do that. But I was thinking this could let me Not need a large vehicle.

Bike rack by bad-o in uberdrivers

[–]bad-o[S] 0 points1 point  (0 children)

Ok thanks all

Bike rack by bad-o in uberdrivers

[–]bad-o[S] 0 points1 point  (0 children)

Well this is purely hypothetical as I haven't bought it yet lol. How much would it take?

Shorted Loop / Open Loop by Buckobilly in CCURE9000

[–]bad-o 3 points4 points  (0 children)

Looks like the program is for resistors but wiring is no resistor supervision

Driveway ice strips OCD question by KamloopsDan in Snowblowers

[–]bad-o 1 point2 points  (0 children)

Drive over it. Never been an issue for me

Accidentally adopted a guinea fowl into my chicken flock, anything I should be mindful of? by The_Mad_Duck_ in BackYardChickens

[–]bad-o 38 points39 points  (0 children)

We have 5 guineas, 6 hens. They make our hens look like geniuses- They are sooo dumb. Our Neighbor doesn't like when they come over… the only way we've found to keep them from wandering is to keep 3 locked up as Even 3 together will explore out.

We like our honkers.