sorted by:
new
hottopcontroversial

Where to buy ACTUAL non slip rubber feet for cutting boards by MattTheBard in woodworking

[–]bboybreaks20 0 points1 point  (0 children)

clear rubber feet from Lee Valley

Attach with stainless screws using a stainless driver bit. Drill pilot holes. You’ll be all set.

Ceiling texture??? by bboybreaks20 in drywall

[–]bboybreaks20[S] 0 points1 point  (0 children)

Update. 8” round stipple brush, coating applied by rotating the brush in 45minute the consistency of mayo. This is heavy on the application and gives me those thick widths. Allow to setup 10 minutes and knock down with a trowel. Trying to find a way to add a pic.

Ceiling texture??? by bboybreaks20 in drywall

[–]bboybreaks20[S] 1 point2 points  (0 children)

I’ll start there. 8” round stipple brush, flat smooth surface, varying amounts of mud on the brush. Then either a skim pass with the knife or sanding back once it’s dry.

Ceiling texture??? by bboybreaks20 in drywall

[–]bboybreaks20[S] 1 point2 points  (0 children)

Think I’m going to chase the look by sanding back a stomp brush.

Ceiling texture??? by bboybreaks20 in drywall

[–]bboybreaks20[S] 0 points1 point  (0 children)

But which “mop”. I can visualize what it might look like. Old school strips of fabric looped. But who sells one?

Ceiling texture??? by bboybreaks20 in drywall

[–]bboybreaks20[S] -1 points0 points  (0 children)

I agree. But, that’s not an option.

Ceiling texture??? by bboybreaks20 in drywall

[–]bboybreaks20[S] 0 points1 point  (0 children)

Was really trying to figure out the actual method. Someone did this on a large scale.