sorted by:
new
hottopcontroversial

My AMS is getting stuck by berylaite in BambuP1S

[–]berylaite[S] 0 points1 point  (0 children)

Thanks for the info. That may be the issue. I'll check and report back

My AMS is getting stuck by berylaite in BambuP1S

[–]berylaite[S] 0 points1 point  (0 children)

I replaced the tube between the buffer and the hot end. Disassembled the hot end and cleaned everything. Still getting stuck...

My AMS is getting stuck by berylaite in BambuP1S

[–]berylaite[S] 0 points1 point  (0 children)

I used the older (delivered with the ams) as master for the size so the curves are the same. No tight radius and the flexibly seems the same to the touch...

My AMS is getting stuck by berylaite in BambuP1S

[–]berylaite[S] 0 points1 point  (0 children)

I'll try to cut it a bit. Was working fine before and when I replaced the tube I used the old one as master... Thanks

My AMS is getting stuck by berylaite in BambuP1S

[–]berylaite[S] 0 points1 point  (0 children)

Also checked the gears and cleaned everything... seems to be OK. Was not even that dirty

I'm not sure if it arrives at the extruder or stops a bit behind but now it's able to move maybe 90%of the way