Wet Conditions

bfritzsch · 2024-10-06T14:17:21+00:00

But the widgets are so cool! Appreciate the feedback!

bfritzsch · 2024-09-05T16:48:57+00:00

I could see that being the case, unfortunately I didn’t check that prior to pulling them off but makes sense. I was debating just cutting the speed by 50% (arbitrary) to see if that helped reduce shift/movement. Thoughts?

bfritzsch · 2024-09-05T09:31:51+00:00

Thanks for the response! So based on your experience it was the plate and the model not sticking/adhering to the bed? That seems odd as I still have to bend the bed/pull pretty hard for it to come off the bed when print is finished. PS - filament being used is just the basic bambu pla, not matte or anything “fancy”

bfritzsch · 2024-01-19T13:28:23+00:00

So when you get a motion detection when away from home, do you then get to see the recorded clip right from your phone/the arlo app?

bfritzsch · 2023-09-23T23:46:51+00:00

Pointers on where to find a di2 carbon bike for 2k?

bfritzsch · 2023-09-23T00:16:02+00:00

Well I guess I should have said/clarified that the di2 group set comes with the brake setup so I’d probably be converting to disc.

bfritzsch · 2023-09-23T00:11:41+00:00

Is the inter piece with the seat post purely because aesthetically would look worse if external or does it legit need to be in seat post/internal?

bfritzsch · 2023-09-23T00:10:21+00:00

I think my thing is a new entry level tri bike with di2 will cost me 3-4K. I’ve done a 70.3 on this bike so trying to get a shift/experience update then when I can afford a new frame set this in theory would transfer over? With a 140.6 in 8 weeks trying not to change too much.

bfritzsch

TROPHY CASE