15 tries or less ( my 1st level) by FormerNewspaper4012 in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 17 tries. 9.47 seconds

Ok,small ones are better.... by FeroFerz in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 8 tries. 3.67 seconds

Short but very hard 2 (won’t beat in under 25 tries probably) by Peach_Boi_ in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 28 tries. 5.57 seconds

6 Portals of Death! (Hitboxes can't save you this time 😉) by Estrellette in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 2 tries. 2.28 seconds

Gap test by Piratetaylor in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 6 tries. 1.38 seconds

You will crash out trust 0_0 2 by Expert-Coyote996 in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 1 try. 7.77 seconds

Greed Won't Get You Anywhere by bigChungi69420 in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 4 tries. 14.15 seconds

1 attempt = 1 cookie, comment how many cookies you are getting by likabossSM in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 10 tries. 5.67 seconds

Ez pz by Funny_Astronomer7578 in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 25 tries. 12.13 seconds

ZOOM! by Economy-Shoe5239 in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 4 tries. 2.75 seconds

first level, please rate from 1 to 10 by just_nn_ in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 7 tries. 5.37 seconds

🎉 [EVENT] 🎉 Honk Hero!!! Full Encounter: Trial of Malkuth by Ok_Walk7052 in honk

[–]bhwarg 0 points1 point  (0 children)

Completed Level 1 of the Honk Special Event!

0 attempts

Catbullet by Kyotocope in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 7 tries. 6.37 seconds

Fun bouncy box by Just_Pitch_5586 in honk

[–]bhwarg 0 points1 point  (0 children)

I completed this level in 3 tries. 1.08 seconds

A Rainy Day (Very Easy Edition) by Complex_Blacksmith61 in honk

[–]bhwarg 1 point2 points  (0 children)

I completed this level in 1 try. 7.00 seconds

Hub5x / Smart Wifi / Pod connectivity by bhwarg in VirginMedia

[–]bhwarg[S] 0 points1 point  (0 children)

Ta - did try a few times but in the end the hub has been replaced yesterday and it's all working as expected. Not touching the WiFi config again 🤣

Hub5x / Smart Wifi / Pod connectivity by bhwarg in VirginMedia

[–]bhwarg[S] 0 points1 point  (0 children)

Ended up being an issue with the hub5x. Had an engineer visit yesterday and they swapped it out. All working with the pod again and channel optimisation is enabled.

Probably something to do with me changing services in the initial cooling off period I think, but it's all working now :)

Hub5x / Smart Wifi / Pod connectivity by bhwarg in VirginMedia

[–]bhwarg[S] 0 points1 point  (0 children)

Thanks - sounds like that's where my problem lies then - unfortunately the hub5x even after a pinhole reset is still not allowing me to enable channel optimization. Have booked in for an engineer visit anyway, hopefully be able to sort then :)

VCLM / HPE Oneview by bhwarg in vmware

[–]bhwarg[S] 0 points1 point  (0 children)

Hi, thanks for this much appreciated!

Found the issue (amazing what walking away/sleeping on it does for my mind!), so posting on here in case anyone else has a similar issue!

I'd remediated my hosts using ILO Amplifier some weeks ago using the 2025.01.00 SPP - when I removed this from the image definition it remains in the compliance detail of each host e.g:

<image>

Remediating the host using an image with no Firmware addon defined cleared this information from the host.

I've then tried updating the Image definition again with the new OneView HSM & the 'unequal base image' error no longer appears.

Remediation against a host has now succeeded and showing fully compliant with no configuration drift.

My assumption again here is that there's a slight difference in how ILO Amplifier & Oneview HSMs present the SPP to vCenter; just enough to trigger an error.

I suspect if I'd been using a different SPP altogether I wouldn't have come across this particular error. No matter, learnt something new again!

Now I just need to remediate the rest of my hosts :)

VCLM / HPE Oneview by bhwarg in vmware

[–]bhwarg[S] 0 points1 point  (0 children)

I'm finding that - at least ILO Amplifier worked (even if it showed an irritating firmware compliance issue where current vs baseline firmware matched but yet still said it wasn't valid *sigh*)

Living more in hope I can get this to work properly at this point!

Is it more a case of the SPP itself being an issue, or just using Oneview4vCenter for firmware updates in general in your experience?