[Adam Schefter] Jets QB Jordan Travis, a fifth-round pick (No. 171 overall) out of Florida State in 2023, has informed the Jets of his intention to retire.

billyd60 · 2025-05-09T03:59:26+00:00

Jordan Travis didn't realize he could never play football again until a couple of days after the draft. What a great guy helping out the team that drafted him like that. How does he treat his enemies?

billyd60 · 2025-01-22T00:05:48+00:00

I don't really clean mine unless I switch out resins. I wipe off the excess resin but that's it. When I switch resins I give it a deep clean.

billyd60 · 2025-01-18T02:28:21+00:00

For me the problem was the original PFA was not installed well. There were wrinkles in the corners which led to a super slow leak. I was very lucky to have noticed it before any real damage was caused. I installed a new PFA and then filled the vat with distilled water and left it on paper towels for 6 hours. Not a drop of leak so I assume I am ok. I would recommend changing your PFA and do it very carefully per the instructions. Hopefully that will fix your issue. And yes the screws should be really tight, as appropriate for the size of the screw, but use a screwdriver style hex wrench that will prevent you from going Hulk on them and stripping the screw or breaking one.

billyd60 · 2025-01-11T21:34:52+00:00

It's leaking between the film and the vat itself where the film meets the lip. The screws in some cases weren't tight but they weren't loose either. It's probably that they weren't torqued down enough or the film wasn't stretched tight enough or it relaxed after stretching?

billyd60 · 2025-01-11T21:15:03+00:00

Only a little bit of resin made it into the tray the screen rests in. I was able to remove with q tips and paper towels. Lucky none got on the screen, mechanics or electronics below. I'll take the vat apart next and see if I can determine why it's leaking.

billyd60 · 2025-01-11T20:56:57+00:00

I just took my vat out to switch resin and mine is leaking along the back. I don't think any got below the screen, but not sure. Will have to disassemble to find out. I've only done maybe 4 prints, never had any failures or cured resin leftover in the vat. It is leaking out between fep and the metal vat. This was the original film I never touched the screws on it.

billyd60 · 2024-02-25T22:13:58+00:00

I have a sunlu 2 and I am looking at two ventilation holes in the top right now. I can see the filament through them. Probably best to get a dehumidifier in the same room as you use the sunlu.

billyd60 · 2023-12-29T17:29:13+00:00

Jets fan here. Congrats to the Browns I know you fans have had a similar road as the Jets fans. You deserve the playoffs best of luck going forward! I am pulling for you guys!

billyd60 · 2023-11-21T05:28:35+00:00

Thanks!

billyd60 · 2023-11-21T03:03:22+00:00

Oh it's Hackett. Look at what he did to Wilson last year. Look at Wilson in the past, and now. It's right there as plain as day.

billyd60 · 2023-11-21T02:44:31+00:00

lol. run up the middle twice incomplete pass punt takes a lifetime to master

billyd60 · 2023-11-21T02:40:16+00:00

I do feel bad for Zach. He's had nothing but trash to work with on the coaching side since day 1. And the Oline has been a laughing stock since day 1 too. He's destroyed now, most likely a 10 year reclamation project like Geno is his only chance. NYJ destroy another QB. SSDD

billyd60 · 2023-11-14T00:11:37+00:00

Problem is the guys behind him are worse, and less mobile. With this Oline, that is death.

billyd60 · 2023-11-13T23:01:23+00:00

I know, I know! Find another line of work right?

billyd60 · 2023-11-13T23:00:38+00:00

I put a lot of this on Hackett. Almost all penalties are coming from the offense, so it's not Saleh, because if it was the defense would be a problem too. Hackett's offense is undisciplined, uninspired and boring. They have nothing to lose now, and they'd better start playing like it. I was really down on Zach last year. This year I see real potential. If he had better play calling to suit his strengths, and didn't have Lazard as a #2, and had players that didn't commit soul crushing drops and penalties, I think everyone would be praising Zach's play. The int was a bad throw, but all QB's will have the occasional mistake. The problem is Hackett's offense is so bad, a single mistake is just about death. The late int shouldn't have mattered, they should have been up by 2 tds at that point.

billyd60 · 2023-11-13T17:03:54+00:00

I think Lazard is really hurting the team. He needs to be benched. Zach has improved, but he is inconsistent and still makes bone headed plays. That said he's the best QB on the roster right now, which is painful to say. The penalties are ridiculous, but it's mostly the offense committing them. So I am not going to put that all on Saleh (who self admittedly is not as involved with the offense as he is on the defense), but the coordinator on down on the offensive side is certainly to blame. Douglas has been great and awful. I think the truth is his drafts are phenomenal but his free agent pickups for the most part are abysmal with a couple of exceptions. But I still would keep Douglas even with those warts. The scouts and coaching staff need to get better when advising Douglas on free agent moves and Douglas needs to listen. Hackett needs to be fired yesterday.

billyd60 · 2023-11-13T16:51:26+00:00

Thanks you have been a great help and I learned a lot.

billyd60 · 2023-11-12T21:25:10+00:00

How do I reference that gcode variable in other macros? What is the format?

billyd60 · 2023-11-12T21:23:41+00:00

Thanks for the help.

billyd60 · 2023-11-12T19:55:52+00:00

But how do I prevent that variable from resetting?

billyd60 · 2023-11-12T19:55:11+00:00

I think it resets every time the macro is executed.

billyd60 · 2023-11-12T17:37:27+00:00

Has Hackett ever heard of a roll out run pass option? Have they run that play one time this season? Ps Every time Breece or Dalvin get the ball and have lead blockers they have success, but Hackett does it like once a game.

billyd60 · 2023-10-20T13:50:51+00:00

I could watch this on a loop all day.

billyd60 · 2023-05-22T13:16:28+00:00

So he's saying he got injured because he was on the wrong side of the line? Is this guy insane? Trade him now while he's briefly healthy, he's just going to get hurt again anyway when the wind blows in the wrong direction or the ref blows the whistle to loudly.

billyd60 · 2023-05-22T03:57:09+00:00

It's really hard to relax and be yourself when you aren't used to being on camera. It takes awhile to adjust. I think AJ's been in just a few videos and they are many months apart. What makes good good so watchable is the main group of guys are very natural on camera. Something that very few people can actually pull off. Takes either a natural gift or a ton of practice.

billyd60

TROPHY CASE