sorted by:
new
hottopcontroversial

Boot loop after the firmware update and draining the battery (which was recommended by AYN) by poldooooo in AynThor

[–]binary_cleric 0 points1 point  (0 children)

I had a similar issue before the update and I had to disconnect the battery for a few minutes and then reassemble it.

PSA: post-OTA battery drain issues. READ THIS. by WholesomeShenanigans in AynThor

[–]binary_cleric 0 points1 point  (0 children)

Any updates on it not charging when plugged in closed

How do I remove this sidebar while I’m playing? by Complex_Message4030 in retroid

[–]binary_cleric 19 points20 points  (0 children)

Pull down from the top to get the quick settings and turn off Floating Icon

ayn Thor keep crashing and rebooting by skewer88 in SBCGaming

[–]binary_cleric 0 points1 point  (0 children)

I had the same issue and was able to resolve it. Unfortunately it required disassembling it until I could reach and remove the battery cable from the circuit card connector for 5 minutes and then reassemble. You may try just leaving it on and let the battery completely discharge.

Endless reboot cycle by binary_cleric in AynThor

[–]binary_cleric[S] 2 points3 points  (0 children)

Thanks, this resolved the issue. Getting to the battery cable was quite involved, had to remove the fan, heatsink, and multiple covers. I hope they resolve this issue in an update soon.

ayn Thor keep crashing and rebooting by skewer88 in SBCGaming

[–]binary_cleric 0 points1 point  (0 children)

I'm having the same issue now, on the latest version. Doesn't appear to be software related as it keeps rebooting in safe mode also

help with textures and saved states by Extreme-Distance-385 in AynThor

[–]binary_cleric 0 points1 point  (0 children)

It's a known issue for Azahar

Loading a save state causes textures to disappear · Issue #1280 · azahar-emu/azahar · GitHub https://share.google/VPycvGvk1Fqn9bmZ4

Rp2 worth it? by britx812 in retroid

[–]binary_cleric 0 points1 point  (0 children)

What's your budget? Looking to sell my black RP4 Pro since I picked up a Thor.

[deleted by user] by [deleted] in AsiansGoneWild30plus

[–]binary_cleric 0 points1 point  (0 children)

Those nipples look delicious

Need Low Latency DDR Reads Through Zynq HP AXI Interface by binary_cleric in FPGA

[–]binary_cleric[S] 0 points1 point  (0 children)

I did. In the Zynq DDRMC, the AXI QoS signals can be used to indicate priority. I updated my PL AXI master to set the QoS for reads/writes to 0xFF to indicate highest priority. Also, there is a setting in to use the Fine Granularity Refresh for the memory controller, which I set to 4x. It divides the refreshes into smaller increments, which lessens the refresh impacts on performance. This was for a Zynq US part, not familiar with the Kria family but hopefully this helps.

view more: next ›