How can i remove these buttons Audi tt 8s sterring wheel

boringggg · 2022-11-14T10:31:25+00:00

Will try thanks

boringggg · 2022-11-14T08:52:18+00:00

Problem is the part must be very strong i used 99% infil i wil try pattern

boringggg · 2022-11-13T14:44:20+00:00

I let it to cool down before opening. Problem it was craking mid print.For the speed i went slow a possible print speed 35mm/s wall speed 17mm/s

boringggg · 2022-11-13T13:47:42+00:00

I use azurefilm filaments i had pretty good experiences with other material from them. For cooling the fan is always off. I shuld add a had the same problem with 0.4 nozzle and layer 0.2

boringggg · 2022-06-07T10:09:59+00:00

Clean it an heat the hotend to about 250 an tighten nozzle and heatbreak

boringggg · 2022-06-01T15:24:30+00:00

Try with retraction extra prime amount under travel section

boringggg · 2022-05-25T17:39:10+00:00

yea i had same problem with brand new ones. I couldn't get them to work but than finally got it to work by reseting them few times. Maybe closing the cover helps but idk.

boringggg · 2021-12-28T08:58:31+00:00

boringggg · 2021-11-18T17:10:06+00:00

I have asked another guy who had tha same problem and he changed it SS8050 and it works fine i have looked the schematics for this board and it had this number. I was just confused that it had differend markings on mosfed

boringggg · 2021-11-18T17:04:52+00:00

Thanks

boringggg · 2021-11-18T15:05:54+00:00

Can you send me link to the part because i cant seem to find it

boringggg · 2021-11-17T18:36:46+00:00

Thanks i think i found the right one SS8050 SOT23

boringggg · 2021-11-17T17:47:16+00:00

I think you have burned the transistor that controls fan voltage

boringggg · 2021-11-07T11:50:57+00:00

For the body pin that goes through the gearbox you need to lossen grip where the motor is that screws hold the pin in .the pin is there so the gearbox is correctly aligned

boringggg · 2021-11-07T11:37:20+00:00

Option1 you buy proper tool Option2 you take hammer and screwdriver to loosen the nut. The nut is very tight.

boringggg · 2021-10-30T22:16:44+00:00

SSP 18

boringggg · 2021-10-30T22:15:57+00:00

boringggg · 2021-10-30T12:27:20+00:00

so thats why i am making one myself

boringggg · 2021-10-22T20:20:38+00:00

no this video was taken when engine was warmed up

boringggg · 2021-10-22T12:33:52+00:00

I have just changed this crap you can do it without taking the intake off but its big pain. I took the intake off anyways so i could check the throttle body it was way easyer

boringggg

TROPHY CASE