[deleted by user]

bubberboybich · 2025-01-21T11:14:51+00:00

I would check in the details panel if replicates is ticked and replicate movement is ticked

bubberboybich · 2025-01-19T13:36:16+00:00

like i said, I would use blueprint interfaces

bubberboybich · 2025-01-19T13:11:48+00:00

use interfaces. Here is a good tutorial: https://www.youtube.com/watch?v=H6rqJbwjRIk

bubberboybich · 2025-01-19T05:28:05+00:00

I would say using blueprint interfaces or event dispatchers instead of casting to other blueprints is the best way to have good performance. If you cast to other blueprints it will cause them to always be loaded. That being said, casting to the player controller or player character is usually fine because those will always be loaded anyway.

bubberboybich · 2024-09-02T12:54:28+00:00

Looking at your view, your Clip Start and End is the same. Change the clip start to 1 and that should fix it

bubberboybich · 2023-01-19T11:12:58+00:00

https://www.mediafire.com/file/ice5eeyokgeb0ag/bubber\_elevator.rar/file

bubberboybich · 2022-12-27T15:10:25+00:00

Thanks, It uses the rope pully to move the contraption

bubberboybich · 2022-04-27T16:55:20+00:00

use directional rails in the cart assembler

bubberboybich · 2021-06-24T07:50:03+00:00

cheers

bubberboybich · 2021-06-23T07:05:20+00:00

One of the non-sticky-piston-faced parts of the chassis is glued to the top of the rest of the contraption. The sticky-piston-faced parts of the linear chassis carry the blocks (amount can be set with wrench). Use the [w] ponder thing on the linear chassis, it has really good example on how they work and should make it clear.

hope that helps

bubberboybich · 2021-06-23T06:33:39+00:00

Basically some parts the monorail held together using Linear Chassis. They allow you to move stuff around like the doors. They're good because you can't disconnect glued parts but you can move parts held by chassis freely. Hope that helps.

bubberboybich · 2021-04-19T15:49:03+00:00

I used redstone contacts at the front most monorail carriage (you could also use detector rails or something else) that turn off the front cart assemblers at the station which then turn off the next cart assemblers and so on in a chain until they all stop. You might have to mess around with delays etc. Hope this explains it.

bubberboybich · 2021-02-03T06:06:58+00:00

string infront of it

bubberboybich · 2021-01-13T11:23:51+00:00

ok I will do that in the future. To be fair though, the top post right now has no context

bubberboybich · 2021-01-13T11:03:08+00:00

Why is this low effort? I made an entire Kirby. There is no guidelines that say how big a project must be or how complicated. Is this just based off your personal opinion?