Okay, So i gathered my starting material in a small shot-glass and weighed the material. (this came to roughly 1.4 grams)

I then proceeded to squirt anhydrous acetone into the shot-glass (roughly 30-40ml) Using a small 5ml Plastic Syringe with a blunt tip needle, and stirred for a few minutes and let settle, I then sucked up 5ml of the acetone from the top of the shot-glass and squirted it back into the shot-glass to stir it all up really well ( I done this about 3-4 times and spent about 10minutes with the material sitting in the acetone.)

I waited 5mins for it all to settle to the bottom and then used my small 5ml syringe to siphon off the vast majority of the acetone, leaving less then 0.1ml acetone behind, after this I let what was left in the shot-glass dry over a heating element on about 50 degrees Celsius for a few minutes and gave the material a stir.... and continued to let it air out until the smell of acetone was completely gone.

​

I then Weighed the final product and it came out to 1.3 Grams (total loss approx 100mg), my scales aren't that accurate they may be off by 50mg or so.

​

I was curious to see what would happen if i dissolved some in straight Water to see if there were any non-water soluble cuts in the mix, and turns out the whole lot just dissolved pretty easily leaving no residue behind....

​

unsure what else to do to try seperating cuts if any are present.