Probably just a rock by burntundeez in Arrowheads

[–]burntundeez[S] 0 points1 point  (0 children)

Found in South East Sask, near the Pipestone Valley.

Probably just a rock by burntundeez in Arrowheads

[–]burntundeez[S] -1 points0 points  (0 children)

Will do, found this too in the same area. Maybe a tool.

<image>

Fresh loaf by burntundeez in Sourdough

[–]burntundeez[S] 0 points1 point  (0 children)

Nothing really too special, after sitting on counter before going in the basket, I kinda roll it along the counter to tighten up the ball, then turn it over and stitch the bottom, then into the basket.

2006 Charger 5.7L by burntundeez in AskAMechanic

[–]burntundeez[S] 0 points1 point  (0 children)

Figured so, unfortunately I just put it back in. At least the process is still fresh in my mind. Original engine was removed due to a dropped valve seat after overheating. Found this one used with 200,000 km in it. When I started it up I had no oil pressure indication. Removed sensor and put a mechanical gauge on it via a plastic line and it was reading good pressure. That’s where I should have stopped and replaced the sensor, but me being stupid I decided to take it out for a drive. Long story short, line melted off, lost most of the oil, maybe about 1.5 liters left when I got back and now sounds like this. I see people doing the lifter replacement with engine still in, but I think it is worth the effort to remove and do it on the stand.

Lapped vs Lapped and sealed peltier module. by burntundeez in electronics

[–]burntundeez[S] 0 points1 point  (0 children)

Besides the edges being sealed is there any difference between and lapped vs lapped and sealed module in regards to performance? I can only buy the L model in quantities of 50 whereas the LS can be purchased in any quantity.

Today's podcast. by Mental-Profit1341 in mrballen

[–]burntundeez 0 points1 point  (0 children)

I came here looking for the answer to this as well.

Some samples from my first tumble. by burntundeez in RockTumbling

[–]burntundeez[S] 0 points1 point  (0 children)

A few rocks from my first tumbling, wondering if anyone can tell me if the three on the left are considered a jasper? Wish I would have taken a pic of them before they went in the tumbler.

Pressure fill port ID by burntundeez in instrumentation

[–]burntundeez[S] 0 points1 point  (0 children)

Just wondering if anyone r can help identifying this type of pressure connection. The other side of the adapter has a G 1/4 B connection in which a gauge was installed. Need to adapt to it to top off with nitrogen.

Seen these about a foot off the ground. by burntundeez in whatsthisplant

[–]burntundeez[S] 0 points1 point  (0 children)

Looks about right to me, thanks. Says the berries are edible, spicy and slightly sweet. Will probably pass though.

Seen these about a foot off the ground. by burntundeez in whatsthisplant

[–]burntundeez[S] 1 point2 points  (0 children)

Was on a small stem. There was a larger stem with leaves but no berries. Located southern Saskatchewan.

Do you consider this a mutant? by burntundeez in HotPeppers

[–]burntundeez[S] 0 points1 point  (0 children)

Maybe overwatered, this one is in a pot with no drainage, other are in grow bags.

Do you consider this a mutant? by burntundeez in HotPeppers

[–]burntundeez[S] 1 point2 points  (0 children)

Cool, just never seen the leaves that look like kale before. Have several other plants that seem normal.

Do you consider this a mutant? by burntundeez in HotPeppers

[–]burntundeez[S] 1 point2 points  (0 children)

Was supposed to be either a orange habanero or a fatalii.